Samsung DVD-E232 235 335 435 free download

File name SAMSUNG_DVD-E232_235_335_435.rar

2. Alignment and Adjustment 2-1 Location of Test Point SKEW Fig. 2-1 Location of Test Point Samsung Electronics 2-1 Alignment and Adjustment 2-2 Skew Adjustment 2-2-1 Adjustment Spec. and Test Point Test Disc ; Service not Available Test Disc Adjustment Spec. Test Point Adjustment Location TDV-533 "ENV" Screw A / B Chapter 14 Flat Waveform (Main PCB - Component Side) Ass'y Deck - Top Side (See Fig. 2-1) (See Fig. 2-2) Fig. 2-2 Ass'y Deck (Top Side) 2-2 Samsung Electronics Alignment and Adjustment 2-2-2 SKEW Adjustment Method Needed to minimize the variations in Skew of the Pickup unit and to provide optimum match with the recorded signal on the Disc. 1) Connect an Oscilloscope to the "ENV" Test Point (See Fig. 2-1). 2) Connect Power, Open the Tray and Play the TDV-533 Disc, Chapter 14. Set the Oscilloscope Range as follows : (Voltage ; 50mV/Div., Frequency ; 10m Sec.) 3) Adjust the Screws "A" and "B" (See Fig. 2-2) using a Hex screwdirvier until you obtain a Flat Waveform and the picture is stable. Then, go to Chapter 1 and make sure the Waveform is Flat here as well. If not, you have to go back to Chapter 14 and adjust again. If you cannot obtain a Flat waveform, then the unit is defective. Note : The Deck must be in a horizontal position. Use both "A" and "B" screws to adjust. Typical Waveform before Adjustment Waveform after Correct Adjustment Fig. 2-3 Envelope Waveform Samsung Electronics 2-3


>> Download document <<




Similar Service Manuals :
Samsung DVD-518 - Samsung DVD-L100W[1].part6 - Samsung HT-DS400RH EDC[1].part2 - Samsung DVD-HR733XEH.part1 - Samsung DVD-HR733XEH.part4 - Samsung Dvd-e137 s[1].m - Samsung HT-DL100[1].part2 -

 FB -  Links -  Info / Contacts -  Forum -   Last SM download : Cirrus Logic Practical Error-Correction Design For Engineers 2ed 1991

script execution: 0.05 s