SONY HCD-RX33 free download

File name SONY HCD-RX33.pdf

HCD-RX33 SERVICE MANUAL AEP Model UK Model HCD-RX33 is the tuner, deck, CD and amplifier section in MHC-RX33. Model Name Using Similar Mechanism CD SECTION CD Mechanism Type Base Unit Type Optical Pick-up Type TAPE DECK SECTION Model Name Using Similar Mechanism Tape Transport Mechanism Type DECK-A DECK-B HCD-G101 CX3 KSM-213BCM KSS-213B/S-N HCD-G101 TK20FX-SW943-800 TK20FX-SW943-800 SPECIFICATIONS The following measured at AC 230 V 50 Hz; DIN power output (Rated) 25 W + 25 W (6 at 1 kHz, DIN) Continuous RMS power output (Reference) 35 W + 35W (6 at 1 kHz, 10% THD) Outputs PHONES (stereo phone jack) : accepts headphones of 8 or more SPEAKER : accepts impedance of 6 to 16 CD player section System Laser Laser output Tape deck section Recording system Frequency response 4 -track 2 -channel stereo 60 ­ 13,000 Hz (± 3dB), using Sony TYPE cassette Tuner section FM stereo, FM/AM superheterodyne tuner FM tuner section Tuning range Antenna Antenna terminal Intermediate frequency AM tuner section Tuning range Antenna Antenna terminals Intermediate frequency Frequency response Wavelength Compact disc and digital audio system Semiconductor laser ( = 780 nm) Emission duration: continuous Max. 44.6 µW* *This output is the value measured at a distance of 200 mm from the objective lens surface on the Optical Pick-up Block with 7 mm aperture. 20 Hz ­ 20 kHz (± 0.5 dB) 780 ­ 790 nm 87.5 ­ 108.0 MHz FM lead antenna 75 unbalanced 10.7MHz 531 ­ 1,602 kHz AM loop antenna External antenna terminal 450 kHz -- Continued on next page -- MINI Hi-Fi COMPONENT SYSTEM MICROFILM SERVICING NOTE General Power requirements 230V AC, 50/60Hz Power consumption 80 W Dimensions (w/h/d) incl. projecting parts and controls Approx. 280 Ч 320 Ч 371 mm (11 1/ 8 Ч 12 5/ 8 Ч 14 5/ 8 in) Mass Approx. 7.2 kg (15 lb 14 oz.) Supplied accessories: AM loop antenna (1) Remote RM-SG5 (1) FM lead antenna (1) Design and specifications are subject to change without notice. NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK OR BASE UNIT The laser diode in the optical pick-up block may suffer electrostatic break-down because of the potential difference generated by the charged electrostatic load, etc. on clothing and the human body. During repair, pay attention to electrostatic break-down and also use the procedure in the printed matter which is included in the repair parts. The flexible board is easily damaged and should be handled with care. NOTES ON LASER DIODE EMISSION CHECK The laser beam on this model is concentrated so as to be focused on the disc reflective surface by the objective lens in the optical pickup block. Therefore, when checking the laser diode emission, observe from more than 30 cm away from the objective lens. CAUTION Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. Notes on chip component replacement · Never reuse a disconnected chip component. · Notice that the minus side of a tan