| Subject | Text |
| A RESISTANCE CHECK ON CAPACITORS IS NOT ADEQUATE AS IT WILL NOT TELL YOU ANYTHING OTHER THAN SHORT O |
| Denon CD-player DCD-920 open/close door | When i operate the open/close button onmy Deon CD-player DCD-920 the CD-door opens, en when it is op |
|
|
| Blaupunkt ist kaput !!! | I have purchased a motor with a Blaupunkt sevilla rd 104 radio/cd.The battery was replaced and I don |
| Hi Minnie,
My Braun EP100 uses a mains cord plugged directly. ( No external pwr-supply. )
The ci |
| thomson 32sw23u icc17chassis with new transformerkit install | hi all have been following some posts on this model and have replaced a blown fbt with the kit from |
| Not quite sure of the question, but here's the info;
In general, it is prefered to have an ESR me |
| i have same problem..its not a crt either..thats BS,
the switch mode transformer on this one, make |
| Hi to you all newbee on forum would like some help please | Hi all hope you are all well
my problem is i would like to slow down an motor that is 12v and gives |
| CD READING PROBLEM | The other gent meant the laser assembly or the motor that spins the disk as being under suspision.
|
| XBox DVD Drive | I got a ms25 samsung DVD drive I wanna trouble shoot. Ive went on xbox forums and its a bunch of ent |
| [quote:3483673c86="whogoesthre"]electrolytics in the power supply but they look fine, no bulging top |
| Sony KPR-36XBR | Just bought this at a sale. Brought home, set came on but had contaminated green crt fluid. Changed |
| Any questions, replace it. Cap meter will give you a value. Wrong. It will. Esr won't. It will tell |
| Have been out of consumer electronics for some time...I used to see this problem on a regular bases |
| On closer look, obviously the spindle is of a different type that I originally thought. (Hall effect |
| service manual for 3m mp7630 beamer | Hello,
i´m looking for the service manual for this beamer.
the dlp motor is defective and i w |
| Toshibas and the like | Hi there Larry and Tibor,
last night I repaired my Toshiba. Larry, you are completely right, the |
|
|
| I also thought I'd mention to check for ripple on the 12V supply as well, 'cos you might have a duff |
| C707 & E994 | After reading the posts on this site, I felt obligated to post. I ordered the service manual for my |
| DUAL 1214 turntable | Hi,
I'm a new (french) member, and I search a service manual for my first 1214 Dual turntable. It's |
| Sony HCD-H550 CD player and stereo deck receiver | Hello,
My Sony has something wrong when it tries to recognise audio CDs. CD motor spins few times |
| I think you misunderstood me about the plug. The plug I was takling about is at the rear of the CRT |
| Hi,
Just a few questions,
1) Start by checking which cicruit is failing.
E.g. Do you have pow |
| technics technicians | I have an old technics turntable which needs a new motor..can anyone please tell me where i can take |
| RENAULT LAGUNA(94) | [b:181fa4cca1][color=blue:181fa4cca1][/color:181fa4cca1][size=18:181fa4cca1][/size:181fa4cca1]
HI I |
| Home Cinema Jvc TH-A30R DVD NO READ DISC AND NO EJECT | I have a dvd jvc th-a30r and dont open the door, i put one disc manually into the cd case and the mo |
| Check ur secondary side for short circuits like rectification diodes, or
Change the small start |
| no no, if you click on 1st TOSHIBA on that page & scroll down to 21N21.
I'm pretty sure the o |
| [quote:5a5876d182="Anonymous"]I traced back to the input of the motor control IC (SIP #BA6209N) pins |
| potentiometer / rheostat questions | Hello,
I have some 12 volt DC "rope lights" I am putting in my motor home. I am trying |