| Subject | Text |
| It sounds like some filter capacitors have dried out and need replacing. The blown fuse means there |
| hitachi 60fx32b / minnie | I sent an e-mail to Minnie,
Minnie,
I have a Hitachi set 60fx32b that's now dead with protect led |
|
|
| TV SET REPAIRS | :D If you are in any doubt as to your ability to undertake any tv repair-dont!!!
There are certain |
| Pioneer VSx-5900S | I do not get anything on FM or AM but the Vu meter shows a received signal as they fluxuate on left |
| Re: Why model or chassis number is required! | [quote:6df2498d7e="jts1957"]c14147 1.5uf@100v[/quote:6df2498d7e]
Ummmmmmm........not sure what t |
| Philips...I must own the only one like this on the planet. | Hello, I have a Philips 64PP9701 (RPHDTV).I have found little to no info on this set. Philips will n |
| Let us assume that this is a fully conventional set without automatic cut-off control.
Then, if y |
| Re: Post subject: Re: Outputs Transistors keep blowing - NAD | [quote:2be425c186="Bunyip"]Thanks vtech, I had heard of this once before but it was not explained to |
| Which transistor blew? Was it a main output transistor or smaller one in the pre-amp stages? Why did |
| [quote:18a63d2739="jts1957"]I put a new diode in D31 and everything connected. [color=red:18a63d2739 |
| Maybe you could sell your daughters and buy a big screen? LOL
Sorry:)
I am not familiar with y |
| Minnie i don't have a juvenator. i turned down the red bias and the bleeding goes away, but it seem |
| Need a data sheet | Hi!Guys,i need data sheet suzuki alto 1000cc 2003 model odometer display driver ic,ic # is MG7372_42 |
| Yamaha EMX512sc Power supply fixed! | Hiya
I just managed to fix a Yamaha SMPS board today after hours of work so I thought I'd share wit |
| So a cap meter will give you a value but doesn't mean the caps good. 1uf = 1mf but if dry, could be |
| minolta 1054 | it is verry important to run F8. and to settings C7 on 1, C5 on 2, and in location 4 (meter count-st |
| hope you discharged the smoother cap b4 you started arsing about. take it to a professional as the a |
|
|
| Shit! didn't want to do this but here we go.
Be sure to input the correct signal format for the d |
| Changing sound channel to 6 from 5.5 for Proline 418B/TX807 | Hello,
Have a UK TV in Australia, which doesn't recieve sounds as the sound channel is set to the |
| Any questions, replace it. Cap meter will give you a value. Wrong. It will. Esr won't. It will tell |
| Re: the best procedure to check ultra fast diode by analogme | [quote:92cd8e0d7a="newone"]the best procedure to check ultra fast diode by analogmeter
what is t |
| dim ELD display | Hi.
I'm trying to repair my Sony DHC-MD333. The main ELD has suddenly become very dim - the displ |
| Re: konica 7155 developer | Konica 7165/7155 Developer Dumping Solution
The Konica 7165/7155 models are known for developer du |
| 13,8VDC Power Supply won't support a load. | Purchased two used 13.8VDC Astron Power Supplies at the Harvard-MIT Flea Market and both are defecti |
| the only advice i can give is to check that all the connectors are firmly pushed in check the fuses |
| With meter set to diode test ... NEW (NEVER installed in your unit) and Suspect IC setting on a desk |
| NationalVCR NVG7A Service manual & circuit and data shee | I desparately need to find the circuit ,data sheets and any service manual for this trusty old warri |
| DeskJet 6550 Alignment Guide? | My 15-month-old son somehow got his hand into my older HP DeskJet 6550 and pulled out a thin plastic |
| If the brightness has detoriated over the years due to wear of the CRT, then you can restore somewha |
| Another method of testing small capacitors in the range of some tens of picofarads is to connect a p |