Text preview for : 2LW-013.pdf part of Kyocera 2LW-013 Kyocera Printer FS-3040-3140MFP SERVICEBULLETIN 2LW-013.pdf
Back to : 2LW-013.pdf | Home
Service Bulletin
SB Number: SB 2LW-013 Creation Date: 06/12/2011
Firmware upgrade (Scanner v002.001 and Fax boot/APL
Subject:
v007.002)
Model: FS-3040MFP/3140MFP
Item Contents
1 Skipped parts of the Phenomena
image on the print-out. If the DP is closed during scanning of the original, when the copy job is started, while
opening the DP after placing the original on the contact glass, the following
phenomena may occur:
1. Only the leading edge of the image may appear on the print-out.
2. Only the trailing edge of the image may appear on the print-out.
This should not occur when copying with the DP.
2 Solenoid motion failure. The DP reverse solenoid may not be released after completing Duplex scanning.
Firmware
Type Program No. Check SUM Version Status Date Applicable model(s)
ENGINE 2LW_1000004001 6EAA 004.001 10/06/2011 FS-3040MFP/3140MFP
MAIN 2LW_2F00008003 ---- 008.003 ---------- FS-3040MFP
MAIN 2LX_2F00008003 ---- 008.003 ---------- FS-3140MFP
SCANNER 2LW_1200002001 ---- 002.001 10/06/2011 FS-3040MFP/3140MFP
FAX BOOT/APL 2H9_5500007002 ---- 007.002 ---------- FS-3140MFP
Note: Please upgrade all the firmware at the same time.
Classification Entire stock rework X In-field modification by case No modification necessary
In-field modification at next visit
Field measure When the above mentioned phenomena occur, please upgrade the firmware to the latest
version.
Serial numbers of affected machines
Type Serial number
FS-3040MFP/3140MFP October 2011 production.
The above mentioned changes have been applied to machines produced after the above mentioned production date.
KMIS Service Department, Kyocera Mita Europe Page 1 of 1 B382 / SB 2LW-013