Text preview for : Service Bulletin DZ10-118.PDF part of DENON Service Bulletin DZ10-118 DENON Blu-Ray Disk Blu-Ray Disk Denon - DBP-4010UDCI Service Bulletin DZ10-118.PDF
Back to : Service Bulletin DZ10-118 | Home
100 Corporate Drive Mahwah, NJ 07430
Service Bulletin
No. : DZ10-118
Date: August 31, 2010
_____________________________________________________________
Model: DBP-4010UDCI
Subject: Correction of the firmware of DPMS (D&M Product Management
Server).
Countermeasure is applicable only upon claim from the customer.
Symptom: DVD disc Schiller "Tagtraum" might be not reproduced.
Solution: We corrected the firmware so that no malfunction occurs.
METHOD OF UPDATE via DPMS (D&M Product Management Server)
Please do not use Proxy for updating in the Network environment! If customer
uses setting of Proxy, the unit doesn't update the firmware properly
Caution: It is necessary to initialize the unit before the update work begins. The
customer has to initialize their BD/DVD Player. Please update the firmware after
you confirm this matter to the customer beforehand.
Updating the firmware (Refer to the Instruction Manual.)
1) Turn the Power Supply of the unit off.
2) Connect the Ethernet terminal of the unit to the Network line by Ethernet
straight cable. (Don't use Ethernet cross cable.)
3) The connection of the network recommends the Ethernet cable for certain
update.
4) Turn the Power Supply of the unit on.
5) Remove the Disc from the Tray.
6) Please confirm! "NO DISC" on the FL Display.
7) The unit sets the Internet. It wishes waiting for about two minutes until
customer's router ends the setting.
______________________________________________________________________________________
CONFIDENTIALITY NOTICE:
The information contained in this document is intended for the exclusive use by DENON Authorized Service Centers and their
employees. This document may contain information that is privileged, confidential and may be protected from disclosure under
applicable laws and terms of the DENON Service Agreement. Any distribution, disclosure, dissemination or copying of this
document and the information it contains is prohibited. No responsibility will be accepted by DENON for any damage, injury or loss
resulting from the misuse of the information contained in this document.
Caution: The update doesn't succeed when the customer's set cannot hook up to
the Internet correctly. In this case, please confirm the internet environment of the
customer's house. If Internet radio can be connected then the internet connection
is good. There are some problems under the internet environment when the
Internet radio can not be received.
8) Press "SETUP" button on the Remote control and indicates the GUI menu.
9) Press "CURSOR" button.
10) The GUI indicates, "Other Setup" > "Firmware Update".
Caution: The update interrupts when it is not possible to connect it with the
Internet correctly. In this case, please do from 1) again.
______________________________________________________________________________________
CONFIDENTIALITY NOTICE:
The information contained in this document is intended for the exclusive use by DENON Authorized Service Centers and their
employees. This document may contain information that is privileged, confidential and may be protected from disclosure under
applicable laws and terms of the DENON Service Agreement. Any distribution, disclosure, dissemination or copying of this
document and the information it contains is prohibited. No responsibility will be accepted by DENON for any damage, injury or loss
resulting from the misuse of the information contained in this document.
11) Select the "Start" on GUI.
12) Press the "ENTER" button.
13) The firmware will start updating.
Caution: When the firmware update starts correctly, the GUI and the audio
signal, etc. stop everything, and become the update operation.
14) When updating starts, the power indicator lights red.
15) The GUI display disappears, and becomes only FL display.
16) During update, a rough remaining time is indicated on the display. When
updating is complete the power indicator lights green and