| Make | Model | Problem | Solution | Date |
| | | |
| Found: 51
|
| Beko | 11214T | Int no pic - sound ok | thyristor T701 ESM740 goes o/c intermittently ESM740 no longer available, use TR03-400T and add a 47 Ohm 0.5W resistor from gate to ground. | 14-09-04 |
| Beko | 11214T | Int no pic - sound ok | T701 thy ESM740 goes o/c int - NLA -- use a TR03-400T & add 47R ?w resistor from gate to ground | 14-09-04 |
|
|
| Beko | 11221T | Dead | psu working - no line drive - line dr tfmr | 14-09-04 |
| Goodmans | F11 2875 | Dead stuck in st/by | R170 O/C safety resistor from secondary off chopper transformer due to IC8 TDA1521 audio output S/C. | 14-09-04 |
| Goodmans | F11 2875 | Dead with TR15 S2000N S/C | Replace S2000N and C102 100ufd which was down to 20ufd | 14-09-04 |
| Goodmans | F11 2875 | Flat looking pic with one or more cols missing | Check feedback res R26, R28, R29 68k on crt base | 14-09-04 |
| Goodmans | F11 2875 | Won't sw back on after st/by selected | Check all elects in psu pri | 14-09-04 |
| Goodmans | F11 2876 | Low emission crt symptom | Check feedback res R26, 28 & 29 68k on crt base | 14-09-04 |
| Nordmende | F9 Chassis (Control board with SAA1121/SAA1130/SAA1020) | Snow on screen, all leds lit, stuck on UHF band. | Change SAA1121. | 14-09-04 |
| Philips | 10CK1120 | Dead | T9629 BUZ71 s/c due to dry joints LOP stage | 14-09-04 |
| Philips | 10CX1120 | Chan display "88", slight tuner drift, no chan change, pic goes dark, sound drops, won't sw on from cold, screeching from LOPTx & LOPTr gets hot etc | Line ripple on supply lines due to pin 12 LOPTx high resistance connection to chassis earths | 14-09-04 |
| Philips | 10CX1120 | Dead on battery - ok on mains | C23 1µ in psu - also D37 o/c causing 8v supply to be slightly high (did not affect operation) | 14-09-04 |
| Philips | 10CX1120 | Dead. | T9629 ( BUZ71 ) s/c , plus drys around LOPTX. | 14-09-04 |
| Philips | 10CX1120 | FIELD INT CRAMPS , SOMETIMES COLLAPSES | C582 10nF ON PIN 20 TDA1770 FIELD IC | 14-09-04 |
| Philips | 10CX1120 | Field scan erratic with cramping across centre | C582 10nF ceramic cap leaky - pin 20 TDA1770 | 14-09-04 |
| Philips | 10CX1120 | Servicing the Philips 10CX1120 | See TV Mag Jan 1995 | 14-09-04 |
| Philips | 10CX1120/05 | Dead - micro TMS3757ANL-10 | T273 BC557 s/c in AV/RF sw cct also | 14-09-04 |
| Philips | 10CX1120/05 | Dist raster & no field sync at sw on - clears aft 10 mins | Mains bridge rect int goes o/c | 14-09-04 |
| Philips | 10CX1120/05 | Raster - distorted & no frame sync. | SKE bridge recy. | 14-09-04 |
| Philips | 10CX1120/05R | power supply working but no line drive. | changed the following T539 / T534 / R537 / R502.
LOPT faulty | 14-09-04 |
| Philips | CX1120 | Dead | Insufficient line drive to turn on LOPTr - T534 BC637 low gain | 14-09-04 |
| Philips | CX1120 | Display - int. | DJs on earth tags 10 , 16 , 18 , L622 or tuner earthing. | 14-09-04 |
|
|
| Philips | CX1120 | Sound varying. | DJs on earth tags 10 , 16 , 18 , L622 or tuner earthing. | 14-09-04 |
| Philips | G111 25GR6771/79 | Dead, no st/by led | replace 2SC3975B (wont oscillate ) in primary of power supply | 14-09-04 |
| Sony | KPS112U (proj) | Int convergence | D/Js on one of the STKs on convergence panel gain access to the convergence panel by taking off the panel below the screen at the front. | 14-09-04 |
| Sony | KVDX2112U | No pic - sound ok | Replaced R807 & D803 [ replaced with 2X BYT11-1000 in series ]. | 14-09-04 |
| Toshiba | 2112 , 2512 , 2812 | TRIPPING IN ANY MODE | D807 O.C. TYPE BYD33J | 14-09-04 |
| Toshiba | 2112 , 2512 , 2812 | TRIPPING IN NORMAL MODE OK IN STBY. MODE | D813 13v ZENER FAULTY | 14-09-04 |
| Toshiba | 2112 - 2812 - 25 | VIBRATION FROM FRONT OF CABINET | REFIT CHAN - VOL BUTTONS ADDING FELT ALONG THEM | 14-09-04 |
| Toshiba | 2112 -252 | BLACK FLASHING LINES RUNNING UP THE SCREEN WORSE W | ICV01 TA8777N AV SWITCHING IC | 14-09-04 |