| Make | Model | Problem | Solution | Date |
| | | |
| Found: 27
|
| Beko | 116328NX | Blank grey raster with white line at top | R815 22R in 16v supply o/c as C712 4µ7 hi esr also C811 220µ hi esr (16v supply line had risen to 29v) | 14-09-04 |
| Beko | 16326NX | Dead/st/by only or partial line coll | C805 330nF 400v dry joints or burnt | 14-09-04 |
| Beko | 16328 | dead | s/c lopt use HR7218 | 14-09-04 |
| Beko | 16328NTX | Blank raster with EHT present | Dry joints T104 5v reg | 14-09-04 |
| Beko | 16328NX | Blank red raster - sound ok | No volts coll T1205 - R1215 22k 1w on crt base | 14-09-04 |
| Beko | 16328NX | Dead aft LOPTx changed | Micro SDA20563A516 faulty | 14-09-04 |
| Beko | 16328NX | Keeps auto tuning to same chan | R61 27k 2w o/c - feeds 30v zener from 200v supply | 14-09-04 |
| Beko | 16328NX | No front panel control - r/c ok | Child lock on - to remove hold "+" & "-" buttons whilst sw on tv | 14-09-04 |
| Beko | 16328NX | No mono sound | Faulty IF can - pt no BEKO63S140 | 14-09-04 |
| Beko | 16328NX | No pic unless A1 increased, then same again next time sw on | IC501 TDA4680 | 14-09-04 |
|
|
| Beko | 16328NX | poor field lin | R717 1M hi res | 14-09-04 |
| Bush | 2163NTX | Dead with smoke | R809 0R47 fusible burnt; s/c chopper tfmr | 14-09-04 |
| Bush | 2163NTXA | Int sound | caused by bad joints UL302 coill near TDA2546 on Nicam pcb | 14-09-04 |
| Finlux | 1632 | EW & WIDTH FAULT | Lz4 DRY Rz26 10k OC Tx4 BD214A SC | 14-09-04 |
| Finlux | 1632 | Excess width & EW dist | Lz4 dry joints, Rz26 10k o/c, Tx4 BD241A s/c | 14-09-04 |
| Philips | 14PV163 | Codenumber information | The codenumber for the spacer between on/off switch and the knob (pos 3) is 4822 402 10702. | 14-09-04 |
| Philips | 14PV163 | Key set | The key set assy has been codified for all B-range TVCR's. This will allow to change the keys without having to change the complete frame. Servicenr. 4822 410 11075 - Key set for:
14PV263/01/02/08/13 - 14PV264/39 - 14PV163/05 - 14PV172/01/05/08/13/39 - | 14-09-04 |
| Philips | 14PV163 | Reverts to st/by at sw on | Sw tr7352 in middle of pcb | 14-09-04 |
| Philips | 14PV163 | Spare part information | Sets produced from week 9608 until 9647. Motor holder with reverse prism included:
In sets produced before week 9647 the reverse prism is a fixed part of the chassis and not available as a spare part.
From week 9647 onwards a motor holder (pos.40) with | 14-09-04 |
| Philips | 14PV163/05 | Codenumber information - new software | A new software version (PTCP2-7) is available for the control uP (IC 7801). Service codenumber is 4822 209 15271.
This new version is only used in the following sets:
14PV263/01, 14PV162/01, 14PV162/05, 14PV162/07, 14PV163/05,
14PV163/05H, 14PV263/01 | 14-09-04 |
| Philips | 14PV163/05 | Line pairing on off air pics - ok on pback | Dist at vid o/p from if - tuner faulty type U944C-IEC | 14-09-04 |
| Philips | 14PV163/05 | Reverts to st/by aft a few mins | Caused by problem triggering prot cct. Usually D6513 BAV21 flyback boost cap in FOP stage - use BYD33J in lieu | 14-09-04 |
| Philips | 14PV163/05H | Codenumber information - new software | A new software version (PTCP2-7) is available for the control uP (IC 7801). Service codenumber is 4822 209 15271.
This new version is only used in the following sets:
14PV263/01, 14PV162/01, 14PV162/05, 14PV162/07, 14PV163/05,
14PV163/05H, 14PV263/01 | 14-09-04 |
| Philips | 14VP163 | WHITE RASTER WITH FLYBACK LINES THEN STANDBY | REPLACE R3592 | 14-09-04 |
| Samsung | CI1630 | won't go to stby | C806 and C808 100uF 25V | 14-09-04 |
| Toshiba | 2163DB C6S | No line sync from cold, sound mute appears only momentarily, unable to enter service mode | CB12 560p low cap - sync pulse feed to pin 34 QA01 | 14-09-04 |
| Toshiba | 2163DB C6S | Poor character width in Text mix. | Q501 TB1229N poor , replace with improved type - TB1229AN PtNo B0102070 | 14-09-04 |