| Make | Model | Problem | Solution | Date |
| | | |
| Found: 22
|
| Ferguson | C3615U Combi | Switches off aft 10 secs with tape jammed | RW002 1R 1w safety res on deck pcb - also check fuse link FW003 (behind on/off sw near white ribbon conn) | 14-09-04 |
| Ferguson | C3615UT | Hotel mode removal | Press simultaneously on the PR-, STOP and AC on/off button on the front of the combi. Adjust using arrow keys on the remote, press ok. | 14-09-04 |
|
|
| Ferguson | C3615UT | Hotel mode reset | Press PR-, STOP & AC on/off button on front of combi. Adj using arrow keys on R/C, press ok. | 14-09-04 |
| Ferguson | C3615UT | No R/C response | 3 legged IR Rx faulty | 14-09-04 |
| Ferguson | C3615UT | Txt int lost | QX51 27Mhz Xtal on Txt pcb replaced | 14-09-04 |
| Ferguson | TX807 M3615UT | Dead apart from red LED pulsing - In Child Lock | To release - Sw on TV at mains whilst holding in Magenta Txt key | 14-09-04 |
| Ferguson | TX807 M3615UT | LED stays green for 6 secs at sw on then reverts to st/by | DL04 BY288 in E/W mod cct leaky | 14-09-04 |
| Grundig | Super Color 8615/8415/8215/8115 | Won't start, no EHT present. | Di518 Sced. It's located behind the large 15uF nonpolar cap.(C532) | 14-09-04 |
| Luxor | 18066151 | EW ACTION VARIES | EW COIL CORE LOOSE - GLUE!!! | 14-09-04 |
| Luxor | 18066151 | Width & E-W varies | LH05 has loose core | 14-09-04 |
| Philips | MG1.1 28PW6615 | At sw on st/by LED lights then goes amber & starts to flash - in prot mode | St/by relay 4822 280 10375. this is listed as 1P 5V 10A JW1AFSN | 14-09-04 |
| Philips | MG1.1E 28PW6615C | poor audio level from rear speakers in dolby mode | remove SMD resistor R3735 located on copper side of LHS of the large signal panel | 14-09-04 |
| Philips | MG1.1EAA 32PW6615/025 | Int start up with LED flashing | relay 1002 in psu pt no 2422 1320 7405 | 14-09-04 |
| Telefunken | 415/615 | Controls not working - front or R/C | Wiper contacts on on/off sw - replace sw | 14-09-04 |
| Telefunken | 615 | Blue screen & fb lines at sw on | Dry joints on col decoder / driver pcb by trs and diodes | 14-09-04 |
| Telefunken | 615 | Dead - blown fuse. | Chopper ( S527T or 2SC1413 ) s/c , T462 ( BC368 ) , D538 2.1v | 14-09-04 |
| Telefunken | 615 | displays "88" & wont sw on until heated | C141 0.033µ between pins 9 & 10 of fop chip | 14-09-04 |
| Telefunken | 615 615 | Dead. | C99 leaky , R242 ( 330K ) o/c. | 14-09-04 |
| Telefunken | 615 615 | Switching off after a few mins. | T482 ( BC2378 ) leaky. | 14-09-04 |
| Telefunken | 615A | There was a narrow , concave picture. with foldover | The line scan coupling capacitor C 184 ( 0.235uF , 250V ) was open-circuit. | 14-09-04 |
| Telefunken | Chassis615A | Int. Brightness flashing and vertical lock hick-ups. | Change 2,1 volts zener in PS. Actually it is a Silicon stabilizer and forward biased, unlike a zener. It can be replaced by three 1N4148 diodes in series. | 14-09-04 |
| Thomson Ferguson | 14CB25UT C3615UT | No pic - sound ok but reverts to st/by aft 5-10secs | DL07-BY228 in e/w stage | 14-09-04 |