| Make | Model | Problem | Solution | Date |
| | | |
| Found: 47
|
| Bush | BC6004 | Blowing line o/p transistor | D687 ( SKE4F1/10 ) , D688 ( BY223 ) , C688 ( 0.0013uf ) , R941 ( 100k ) | 14-09-04 |
| Bush | BC6004 | Dead | BU326A T686 s/c, when replaced has slow tripping - tripler faulty | 14-09-04 |
|
|
| Bush | BC6004 | Tripping | D687 ( SKE4F1 ) Faulty Blows Up C835/6 If Left Tripping . | 14-09-04 |
| Bush | BC6004 | Tripping - as Picture Comes On | Check/Replace D956 ( sync/control PCB ) | 14-09-04 |
| Bush | BC6004 | Tripping - as Picture Comes On | Adjust P943 For 122v at R886. | 14-09-04 |
| Bush | BC6004 | Tripping - intermittently. | R943 ( 330k ) gone high. | 14-09-04 |
| Bush | BC6111 | Tuning drift. | Check/replace 9Z1 | 14-09-04 |
| Bush | BC6318 | No or intermittent sound. | Dry joint from 1Z7. | 14-09-04 |
| Bush | BC6338 | Channel selector stuck on prog. | ET6016 , 1R1106. | 14-09-04 |
| Bush | BC6338 | Tuning - no channel change. | ET6016 &/or 1R1106 | 14-09-04 |
| Bush | BC6348 | Dead | 4D14 | 14-09-04 |
| Sharp | BCTV-A | E-W dist | IC500 | 14-09-04 |
| Sharp | BCTV-A | no pic - smell of burning | R619 & 632 cooking due to C619 s/c | 14-09-04 |
| Sharp | BCTV-A | No/int FM mono,NICAM or scart sound,whistling | NV memory reqs reprog - data from Sharp, WVE - not in serv man | 14-09-04 |
| Sharp | BCTV-A DV6635H | Dead with burning smell | C706 1n 2kv burnt | 14-09-04 |
| Sharp | BCTV-A DV6635H | E/W dist & onlt top half of field scan | L604 15µ melted due to C607 0µ56 250v low cap | 14-09-04 |
| Sharp | BCTV-A DV6635H | E/W faulty | TDA3850 field/EW o/p chip | 14-09-04 |
| Sharp | BCTVA 66AS06H | Tripping, LOPTr s/c & R619/632 burnt | Replace faulty comps & C619 0µ56 | 14-09-04 |
| Sharp | BCTVA DV5932H | at switch on reverts back to stby | C725 220uF10V, C729 470uF 16V | 14-09-04 |
| Sharp | BCTVA DV5932H | dead or tripping | TDA8350Q s/c, C627 1nF 2kV leaky | 14-09-04 |
| Sharp | BCTVA DV5932H | E-W error | replace frame IC and 36V zener (s/c) | 14-09-04 |
| Sharp | BCTVA DV5932H | Ok from cold, then pic starts to flash | IC500 TDA830Q | 14-09-04 |
|
|
| Sharp | BCTVA DV5932H | pic moved to top, E-W distortion | L604 shorted turns (RCILP0104CEZZ) | 14-09-04 |
| Sharp | BCTVA DV5935H | dead, LOPTr s/c | C712 100uF 50V, L700 VPCF3R3K0000-1, R715/R734 0.56R 2W (VRN-VV3DBR56J), IC700 MC44602 (RHIX1487BMZZ), Q705 2SD1546, Q600 2SD1546, D718 1N4732 (RHEX0487BMZZ) | 14-09-04 |
| Sharp | BCTVA DV5935H | stuck in stby | LOPTr Q600 2SD1546, C619 (marked C617) 0.56uF 250V swollen (RC-FZ6564BMNJ), R619/R632 39R 0.5W burnt. Check pin 11 of IC500, if s/c replace IC500 TDA8350Q (RHIX1471BMZZ) | 14-09-04 |
| Sharp | BCTVA DV5935H | takes about 10 presses to switch on | R721 5R6 gone high | 14-09-04 |
| Sharp | BCTVA DV5935H | text vibrates after frame IC replaced | wrong type IC used, use RHIX1471BMZZ | 14-09-04 |
| Sharp | BCTVA DV6635 | Dead - lop tr s/c | dry joints scan coils, R619 & 632 39R ?w o/c - C619 0µ56 o/c | 14-09-04 |
| Sharp | BCTVA DV6635 | Repeated failure of lop tr | Dry joints at yoke end of scan coil connector or L603 | 14-09-04 |
| Sharp | BCTVA DV6635H | No sound | multiplexer IC303 HEF4053BP - can also be caused by corrupt eeprom | 14-09-04 |