| Make | Model | Problem | Solution | Date |
| | | |
| Found: 13
|
| Alba | CTV6682 | Blank raster | TDA8362A in prot mode - C707 in field fback volts supply | 14-09-04 |
| Alba | CTV6682 | Field coll & no sound | No volts at ramp gen pin 43 TDA8362A; R818 22k o/c | 14-09-04 |
| Alba | CTV6682 | Field collapse | R181 22k in 33v supply gone hi | 14-09-04 |
| Alba | CTV6682 | Int then dead | chopper tfmr dry joints | 14-09-04 |
| Alba | CTV6682 11AK12 | green flyback lines can be seen on the picture, otherwise is Okish | no green output from TDA8362A(2Y), the IC is u/s - caused by intermittently arcing LOPTx (HR6465). | 14-09-04 |
| Goodmans | GTV66W 1 11AK19 | Blank raster | small RGB panel on CRT pcb had broken print (not surprising as it gets a lot of physical strain) | 14-09-04 |
| Goodmans | GTV66W 1 11AK19 | Bright white raster at sw on then trips off | No volts to TDA6107Q RGB o/p chip on crt base as 47R safety res R914 on base o/c - dry joint on A1 conn of crt base & others probably caused it | 14-09-04 |
| Goodmans | GTV66W1 11AK19 | Dead - LOPTx s/c, when replaced, E-W errors | D611 (BY299) was leaky | 14-09-04 |
| Goodmans | GTV66W1 11AK19 | E/W dist | Dry joint C613 12nF, R629 27R safety res o/c, C630 390nF 250v low cap | 14-09-04 |
| Goodmans | GTV66W1 11AK19 | Narrow pic | C630 dry R629 2.7R burnt. Also replace D612 BY228 | 14-09-04 |
|
|
| Goodmans | GTV66W1 11AK19 | Tripping | Audio O/P IC TDA2615 | 14-09-04 |
| Goodmans | GTV66W1 11AK19B-1 | Width reduced & no E-W | C630, R629 2R7 and the BUK444 200A. | 14-09-04 |
| Goodmans | GTV66WI AK19 | Dead with rapid ticking | C630 390nF dry joint, BU2508AF LOPTr s/c | 14-09-04 |