Make | Model | Problem | Solution | Date |
| | | |
Found: 30
|
Broksonic | CTSGT8118T | Dead, Q501 2SD2578 s/c | When replaced, came on with bright white raster - IC45 TDA6107Q & R996 (10R 1/2w?) | 14-09-04 |
Bush | 1435GTV | Dead - fuse intact | Q801 s/c - replace with BUZ90AF, R809 0R47 & IC801 | 14-09-04 |
|
BUSH | 1435GTV | DEAD FUSE OK | REPLACE Q801, R809 AND IC801 TRANBUZ90AF. 0.47 OHM AND IC**TDA4605 | 14-09-04 |
Goodmans | GTV20CTV | Dead | C125 100µ in 12v reg supply line | 14-09-04 |
Goodmans | GTV211 | Field scan patially missing, no sigs | R26 12k in 30v supply rail | 14-09-04 |
Goodmans | GTV211 | Short pic, no vid & green background | Check shorting links 1068/1169 (rear of proc) are not touching together | 14-09-04 |
Goodmans | GTV288 | Dead | Chopper tfmr dry joints caused burn up - resoldered (11AK12-9 chassis) | 14-09-04 |
Goodmans | GTV288 | Remote control wont work apart from bringing set out of st/by | MD501 on front control panel | 14-09-04 |
Goodmans | GTV288 11AK19-8A | Poor contrast - poor sync - no colour -sound intermittent | TDA8843 | 14-09-04 |
Goodmans | GTV288 11AK19 | Dead apart from flashing G LED at sw on | R867 0R33 1/2w o/c (not shown on all ccts) | 14-09-04 |
Goodmans | GTV66W 1 11AK19 | Blank raster | small RGB panel on CRT pcb had broken print (not surprising as it gets a lot of physical strain) | 14-09-04 |
Goodmans | GTV66W 1 11AK19 | Bright white raster at sw on then trips off | No volts to TDA6107Q RGB o/p chip on crt base as 47R safety res R914 on base o/c - dry joint on A1 conn of crt base & others probably caused it | 14-09-04 |
Goodmans | GTV66W1 11AK19 | Dead - LOPTx s/c, when replaced, E-W errors | D611 (BY299) was leaky | 14-09-04 |
Goodmans | GTV66W1 11AK19 | E/W dist | Dry joint C613 12nF, R629 27R safety res o/c, C630 390nF 250v low cap | 14-09-04 |
Goodmans | GTV66W1 11AK19 | Narrow pic | C630 dry R629 2.7R burnt. Also replace D612 BY228 | 14-09-04 |
Goodmans | GTV66W1 11AK19 | Tripping | Audio O/P IC TDA2615 | 14-09-04 |
Goodmans | GTV66W1 11AK19B-1 | Width reduced & no E-W | C630, R629 2R7 and the BUK444 200A. | 14-09-04 |
Goodmans | GTV66WI AK19 | Dead with rapid ticking | C630 390nF dry joint, BU2508AF LOPTr s/c | 14-09-04 |
Goodmans | GTV69W3 11AK19 | Switching from Nicam to Mono then no sound | VL301 on Nicam PCB | 14-09-04 |
Goodmans | GTV69W3BLU4 11AK19pro | R629 value | 2R7 in 28" 4:3; 27R in 28" widescreen; 44R in 32" widescreen | 14-09-04 |
Goodmans | GTV9200 | Int loss of pic temp cured by adj of A1 | C801 2n2 1kv on crt base slight leak | 14-09-04 |
Grundig | G1000 GT2103 | Bright raster with fb lines | R315 10R near LOPTx o/c - supplies volts to RGB | 14-09-04 |
|
Grundig | GT1401 | No sound or pic | 5v supply missing because D114 cathode no soldered thro' print | 14-09-04 |
Grundig | GT2103 | Hum bar | mains smoother 47µ 385v o/c | 14-09-04 |
Grundig | GT2105 | Bright white raster | R315 10R on crt base o/c | 14-09-04 |
Grundig | GT2105 | Dead - HT pulsating | Tr302 LOPTr s/c | 14-09-04 |
Grundig | GT2105 | Dead - no line drive | R315 o/c | 14-09-04 |
Grundig | GT2105 | No Green | R908 on crt base & R802 near RGB chip | 14-09-04 |
Grundig | GT2105 | Unstable pic & sound | 33v tuner supply fluctuating at 25v - tuner faulty | 14-09-04 |
Susumu | GT20 | Field cramping in middle | C307 2µ2 tant | 14-09-04 |