Make | Model | Problem | Solution | Date |
| | | |
Found: 9
|
Ferguson | TX92F | Dead | RP08 270k ?w o/c | 14-09-04 |
Ferguson | TX92F | Switches off aft 5 mins | Change white opto coupler IP60 4N25TV for black type (same no) | 14-09-04 |
Ferguson | TX92F T59NB | Dead sm resistors burnt up under LOPTx | RL07 3k9 & RLo8 10k sm under Loptx & replace LOPTx that caused the fault | 14-09-04 |
Ferguson | TX92F T59NB | Field foldover at top | CF30 47µ 50v between pins 3 & 6 of FOP chip IF01 | 14-09-04 |
Ferguson | TX92F T59NB | St/by only with flashing led | LOPTx & RL08 10k sm under loptX | 14-09-04 |
Goodmans | GD2880D TX92F | Int reverts to st/by | Dry joints CP13 in snubber | 14-09-04 |
Goodmans | GD2880D TX92F | Reverts to St/by aft init EHT rush & brief green LED | TL41 BD681 (s.c.), RL47 3.3 ohms, DL21 BY228 ( S.C.), 1.5uF 160V.W. capacitor (o.c.) | 14-09-04 |
Saba | TX 92 F | LED blinks sharp /faint | Smd RL 08 (6K8) vissible burnt ,replace LOPT ( Orega 40330-26 =HR 7360 ) | 14-09-04 |
Thomson | TX92F | LED flashing at sw on (prot mode) | disable pin 4 of IP 70 IC TDA8139 to over-ride prot cct - shows field coll; IC STV2145 (IF02) was faulty, but still no functs - replaced EEPROM - now bad col with green flashes - jungle chip faulty | 14-09-04 |