Text preview for : m1mv180e.pdf part of panasonic m1mv180e panasonic Video WE-MV180 m1mv180e.pdf
Back to : m1mv180e.pdf | Home
ORDER NO. AVS9506039C8
Video Imager
WE-MV180
SPECIFICATIONS
CAMERA UNIT
Pick-up Device: 752 (H) x 582 (V) pixels, 1/3" Interline Transfer CCD
Scanning System: 2:1 Interlace
Scanning: 625 lines/50 fields/25 frames
Horizontal: 15.625 kHz
Vertical: 50 Hz
Video Output: 1.0 V[p-p] PAL composite/75
S-Video Output: Y: 1.0 V[p-p]/75
C: 0.3 V[p-p] (Burst Level)/75
Horizontal Resolution: 450 lines (at center)
Signal-to-Noise Ratio: 48 dB
White Balance: Automatic
Shutter Speed: 1/120 Flickerless
Lens Unit
Focal Length: 5.4 - 64.8 mm (12X)
Maximum Relative Aperture: F1.8 - F2.7
Zoom: Electronic power
Focus: Auto Focus
Liquid Crystal Display Unit
Size: 2.9 inch
Brightness: Manually adjustable
Resolution: 480 (H) x 130 (V) pixels
C 1997 Matsushita Communication Industrial Co., Ltd.
All rights reserved. Unauthorized copying and
distribution is a violation of law.
! WARNING
This service information is designed for experienced repair technicians only and is not designed for use by the
general public.
It does not contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to
service a product.
Products powered by electricity should be serviced or repaired only by experienced professional technicians. Any
attempt to service or repair the product or products dealt with in this service information by anyone else could
result in serious injury or death.
This symbol warns the user that uninsulated voltage within
CAUTION the unit may have sufficient magnitude to cause electric
RISK OF ELECTRIC SHOCK shock. Therefore, it is dangerous to make any kind of contact
DO NOT OPEN
with any inside part of this unit.
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK). NO USER This symbol alerts the user that important literature concerning
SERVICEABLE PARTS INSIDE. the operation and maintenance of this has been included.
REFER SERVICING TO QUALIFIED SERVICE Therefore, it should be read carefully in order to avoid
PERSONNEL. any problems.
IMPORTANT SAFETY NOTICE
There are special components used in this equipment which are important for safety. These parts are indicated
by the " ! " mark on the schematic diagram and the replacement parts list. It is essential that these critical
parts should be replaced with manufacturer's specified parts to prevent shock, fire, or other hazards.
Do not modify the original design without permission of manufacture.
Main Unit
Video Input: 1.0 V[p-p] composite/75, RCA standard jack (X2)
S-Video Input: Y: 1.0 V[p-p]/75,
C: 0.3 V[p-p] (Burst Level)/75, Mini DIN 4-pin connector (X2)
(Direct out via Input Selector)
Audio Input: RCA standard jack (X2)
Microphone Input: -65 dB/600, phone jack, unbalanced
Video Output: 1.0 V[p-p] composite/75, RCA standard jack (X1)
S-Video Output: Y: 1.0 V[p-p]/75,
C: 0.3 V[p-p] (Burst Level)/75, Mini DIN 4-pin connector (X1)
Audio Output: -20 dBV (1V = 0 dBV), RCA standard jack
Fluorescent lamp: 6W, 12V
Ambient operating Temperature: +5