Text preview for : p06.pdf part of Philips p06 Philips Monitor Monitor CD 2001[1].part02 Monitor CD 2001 E-MANUALS Philips crt 107b2 pdf p06.pdf
Back to : p06.pdf | Home
6 107B2 CM24 GSIII OSD Lock Function & Service Mode
9 Go to cover page
To lock (disable) OSD function:
Access Factory Mode
- Press OSD button " " for over 15 seconds to lock the OSD function. Firstly, get into Factory Adjustment Mode.
Release it, then OSD comes on the screen as below.
Push LEFT & RIGHT buttons at the same time for
over 15 seconds and release them.
ATTENTION The factory message appears at the bottom of the
main OSD menu. (for example : GS3 107B2 V1.41 20000630;
CONTROL MENU IS LOCKED 00115 is M.used hours)
00115
To unlock (enable) OSD function:
- Press OSD button " " for over 15 seconds again to unlock the
OSD function.
Release it, then OSD comes on the screen as below.
GS3 107B2 v1.41 20000630
Access Service Mode
- Disconnect the Interface cable of the monitor.
- Push LEFT & RIGHT buttons at the same time, then power
ON.
- If it is successful, the signal " "
comes on the screen later. SERVICE MODE
MODEL SELECT (Background is white.). SERIAL NO: TY 123456
HOURS : 00021
FACTORY VER 1.01 990706
Exit "Service Mode" :
GS3 107B2 V1.41 20000630 - Apply a normal VGA Signal to monitor, then monitor will exit " service
mode" back to normal.
Disable/Enable all the WARNING SIGNAL
To disable all the WARNING SIGNAL :
- Disconnect the Interface cable of the monitor (Monitor is ON.).
- Press OSD button " " for over 15 seconds to disable all the
WARNING SIGNAL. Then release the "OSD" button.
- If it is successful, then the signal " NO SIGNAL INPUT "disappeared to
enter power saving-off mode.
To enable all the WARNING SIGNAL :
- After disconnect the Interface cable of the monitor, then Monitor is
powered ON.
- If it is successful, the signal " NO SIGNAL INPUT " comes on the
screen again later.
3Back Forward4