Text preview for : p04.pdf part of Philips p04 Philips Monitor Monitor CD 2001[1].part02 Monitor CD 2001 E-MANUALS Philips crt 104s PDF p04.pdf

Back to : p04.pdf | Home

4 104S CM23 GSIII Installation and Control
Go to cover page

Front Controls
Front View For an optimized adjustment of the picture following controls are
available at the front.

1.Press this knob, the green LED lights and the power is ON.
2.Press this knob again, the green LED disappears and
the power is OFF.
Rotate to adjust the picture contrast level.
For detailed information about the knobs and keys, Rotate to adjust the overall screen brightness as a
please refer to controls compensation for ambient light.

Digital Controls
Rear View Press to adjust (increase) the function selected.
Press to adjust (decrease) the function selected.
To select the level of function.
"SHIFT" LED off - control is on first level.
"SHIFT" LED on - control is on second level.

The function pads:
H-Shift: to adjust the horizontal position of the image.
H-Size: to adjust the horizontal amplitude of the image.
V-Shift: to adjust the vertical position of the image.
V-Size: to adjust the vertical amplitude of the image.
Select level of the function pads:
Trapezoid:to correct the trapezoid distortion of the image.
Pincushion:to correct the barrel distortion of the image.
Recall: to recall original factory preset mode.
1.When pressing any function pad, the "Shift" LED will flash
once to indicate the function has been selected.
2.Once the limit of the adjustable range has been reached,
the shift LED will flash continuously.
For the monitor is pre-set with 6 modes for optimal display size
and centering as indicated in the following table:

Frequency Remark
Mode Resolution H(KHz) V(Hz)
M01 VGA 640 x 400 31.5 70 Non-interlaced
M02 VGA 640 x 480 31.5 60 Non-interlaced
M03 VGA 640 x 480 37.5 75 Non-interlaced
M04 SVGA 800 x 600 46.9 75 Non-interlaced
M05 SVGA 800 x 600 53.7 85 Non-interlaced
M06 EVGA 1024 x 768 48.3 60 Non-interlaced
1.Power in - attach power cable here.
2.Video In - this is a cable which is already attached to your
The set will save the user's setting parameters automatically.
monitor.Connect the other end of the cable to your PC. After 10 seconds of key-pad inactivity, the LED will flash twice to
indicaate the parameters being saved.
Press to recall factory preset mode. (at second level)
Back Forward