Text preview for : Panel_BOE_HM236WU1-100_1_[DS].pdf part of . Various Panel BOE HM236WU1-100 1 [DS] . Various LCD Panels Panel_BOE_HM236WU1-100_1_[DS].pdf
Back to : Panel_BOE_HM236WU1-100_1_ | Home
Global LCD Panel Exchange Center www.panelook.com
PROPRIETARY NOTE
THIS SPECIFICATION IS THE PROPERTY OF BOE DT AND SHALL NOT BE
REPRODUCED OR COPIED WITHOUT THE WRITTEN PERMISSION OF BOE DT AND
MUST BE RETURNED TO BOE DT UPON ITS REQUEST
TITLE : HM236WU1-100
Product Specification
Rev.P1
BEIJING BOE Display TECHNOLOGY
SPEC. NUMBER PRODUCT GROUP Rev.P1 ISSUE DATE PAGE
TFT-LCD 2011.8.8 OF 28
B2010-8002-O (1/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT Rev.P1 Aug. 8. 11'
REVISION HISTORY
REV. ECN No. DESCRIPTION OF CHANGES DATE PREPARED
Rev.P0 Initial Release July. 20. 11' Zheng Xiaopan
Rev.P1 2nd Release Aug.8. 11' Zheng Xiaopan
SPEC. NUMBER SPEC. TITLE PAGE
HM236WU1-100 Product Specification_Rev.P1 OF 28
B2010-8002-O (2/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT Rev.P1 Aug. 8. 11'
Contents
No. Item Page
1.0 General Description 4
2.0 Absolute Maximum Ratings 6
3.0 Electrical Specifications 7
4.0 Optical Specifications 8
5.0 Interface Connection 10
6.0 Signal Timing Specifications 13
7.0 Signal Timing Waveforms of Interface Signal 15
8.0 Input Signals, Display Colors & Gray Scale of Colors 17
9.0 Power Sequence 18
10.0 Mechanical Characteristics 19
11.0 Reliability Test 20
12.0 Handling& Cautions 21
13.0 Product Serial Number 22
14.0 Packing 23
15.0 Appendix 25
SPEC. NUMBER SPEC. TITLE PAGE
S HM236WU1-100 Product Specification_Rev.P1 OF 28
B2010-8002-O (3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT Rev.P1 Aug. 8. 11'
1.0 GENERAL DESCRIPTION
1.1 Introduction
HM236WU1-100 is a color active matrix TFT LCD module using amorphous silicon TFT's
(Thin Film Transistors) as an active switching devices. This module has a 23.6 inch
diagonally measured active area with FHD resolutions (1920 horizontal by 1080 vertical
pixel array). Each pixel is divided into RED, GREEN, BLUE dots which are arranged in
vertical stripe and this module can display 16.7M colors. The TFT-LCD panel used for this
module is adapted for a low reflection and higher color type.
LVDS LVDS Rx Source Driver
Input +
Signal T/CON
+
Connector (CN
Gate Driver
Mini LVDS Tx
TFT LCD Panel
1920 1080
VDD DC/DC
LED Connector
1 Gamma
)
Vcom
LED Lighting Bar
1.2 Features
z LVDS Interface with 2 pixel / clock
z High-speed response
z 6-bit (Hi-FRC) color depth, display 16. 7M colors
z Incorporated edge type back-light (LED)
z High luminance and contrast ratio, low reflection and wide viewing angle
z DE (Data Enable) only
z RoHS/Halogen Free
z TCO 5.0 , E/S 5.0 compliant
z Gamma Correction
SPEC. NUMBER SPEC. TITLE PAGE
S HM236WU1-100 Product Specification_Rev.P1 OF 28
B2010-8002-O (3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT Rev.P1 Aug. 8. 11'
1.3 Application
z Desktop Type of PC & Workstation Use
z Slim-Size Display for Stand-alone Monitor
z Display Terminals for Control System
z Monitors for Process Controller
1.4 General Specification
The followings are general specifications at the model HM236WU1-100.
Parameter Specification Unit Remarks
Active area 521.28(H) 293.22(V) mm
Number of pixels 1920(H) 1080(V) pixels
Pixel pitch 0.2715(H) 0.2715(V) mm
Pixel arrangement RGB Vertical stripe
Display colors 16.7M colors
Display mode Normally White
Dimensional outline 544.8(H) 320.5(V) 9.6(D) typ. mm
Weight 2200 (Typ.) g
Surface Treatment Haze 25%, 3H
Back-light Lower edge side, 1-LED Lighting Bar type Note 1
PD : T.B.D (max)
Power Consumption
PBL : 14.9W (max) Note 2
Ptotal : T.B.D (max)
Notes : 1. LED Lighting Bar (4*input pins)
2. PLED=Input pins* VPIN IPIN
SPEC. NUMBER SPEC. TITLE PAGE
S HM236WU1-100 Product Specification_Rev.P1 OF 28
B2010-8002-O (3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT Rev.P1 Aug. 8. 11'
2.0 ABSOLUTE MAXIMUM RATINGS
The followings are maximum values which, if exceed, may cause faulty operation or
damage to the unit. The operational and non-operational maximum voltage and current
values are listed in Table 2.
< Table 2. Absolute Maximum Ratings> [VSS=GND=0V]
Symbol Min. Max. Unit Remarks
Parameter
Power Supply Voltage VDD -0.3 6.0 V
Ta = 25
Logic Supply Voltage VIN VSS-0.3 VDD+0.3 V
LED Light Bar Current
IPIN T.B.D T.B.D mA
Per Input Pin
LED Light Bar Voltage
VPIN T.B.D T.B.D V
Per Input Pin
Operating Temperature TOP 0 +50 1)
Storage Temperature TST -20 +60 1)
Note : 1) Temperature and relative humidity range are shown in the figure below.
Wet bulb temperature should be 39 OC max. and no condensation of water.
SPEC. NUMBER SPEC. TITLE PAGE
S HM236WU1-100 Product Specification_Rev.P1 OF 28
B2010-8002-O (3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT Rev.P1 Aug. 8. 11'
3.0 ELECTRICAL SPECIFICATIONS
3.1Electrical Specifications
< Table 3. Electrical specifications > [Ta =25 2 ]
Parameter Min. Typ. Max. Unit Remarks
Power Supply Voltage VDD 4.5 5.0 5.5 V
Note1
Power Supply Current IDD - T.B.D T.B.D mA
In-Rush Current IRUSH - 2.0 3.0 A Note 2
Permissible Input Ripple Voltage VRF - - 100 mV VDD = 5.0V
High Level Differential Input
VIH - - +100 mV
Threshold Voltage
Low Level Differential Input
VIL -100 - - mV
Threshold Voltage
Differential input voltage |VID | 200 - 600 mV
VIH=100mV,
Differential input common mode voltage Vcm 1.0 1.2 1.5
VIL=-100mV
PD - T.B.D T.B.D W
Power Consumption PBL 13.2 14.1 14.9 W Note 3
Ptotal - W
Notes : 1. The supply voltage is measured and specified at the interface connector of LCM.
The current draw and power consumption specified is for VDD=5.0V, Frame rate=75Hz
Clock frequency = 92.9 MHz. Test Pattern of power supply current
a) Typ : T.B.D
b) Max : T.B.D
2. Duration of rush current is about 2 ms and rising time of VDD is 520 s 20 %
3. Calculated value for reference (Input pins*VPIN IPIN) excluding inverter loss.
SPEC. NUMBER SPEC. TITLE PAGE
S HM236WU1-100 Product Specification_Rev.P1 OF 28
B2010-8002-O (3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT Rev.P1 Aug. 8. 11'
3.2 Backlight Unit
< Table 4. LED Backlight Unit >
Parameter Min. Typ. Max. Unit Remarks
LED Light Bar Input Voltage Per
VPIN 33 35.2 37.4 V Duty 100%
Input Pin
LED Light Bar Input Current Per
IPIN - 100 - mA Note1,2,
Input Pin
LED Power Consumption PBL 13.2 14.1 14.9 W Note 3
LED Life-Time - 30,000 - Hrs Note 4
Note1: There are one light bar ,and the specified current is input LED chip 100% duty current
Note2: The sense current of each input pin is 100mA
Note3: PBL=4 Input pins*VPIN IPIN
Note4: The lifetime is determined as the time at which luminance of LED become 50% of the initial
brightness or not normal lighting at IPIN=100mA on condition of continuous operating at
25 2
SPEC. NUMBER SPEC. TITLE PAGE
S HM236WU1-100 Product Specification_Rev.P1 OF 28
B2010-8002-O (3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT Rev.P1 Aug. 8. 11'
4.0 OPTICAL SPECIFICATION
4.1 Overview
The test of Optical specifications shall be measured in a dark room (ambient luminance d 1 lux and temperature =
25r2 ) with the equipment of Luminance meter system (Goniometer system and TOPCONE BM-5) and test unit shall
be located at an approximate distance 50cm from the LCD surface at a viewing angle of and equal to 0q. We refer to