Text preview for : Panel_AU_Optronics_B150XN01_0_[DS].pdf part of . Various Panel AU Optronics B150XN01 0 [DS] . Various LCD Panels Panel_AU_Optronics_B150XN01_0_[DS].pdf



Back to : Panel_AU_Optronics_B150XN | Home

Product Functional Specification

15 inch XGA Color TFT LCD Module
Model Name : B150XN01



( ) Preliminary Specification
( u ) Final Specification
www.DataSheet.co.kr




Note: This Specification is subject to change without notice.




(C) Copyright AU Optronics, Inc.
August, 2001 All Rights Reserved. B150XN01 Ver.04
1/1
No Reproduction and Redistribution Allowed.

Datasheet pdf - http://www.DataSheet4U.net/
I. Contents
1.0 Handling Precautions
2.0 General Description
2.1 Characteristics
2.2 Functional Block Diagram
3.0 Absolute Maximum Ratings
4.0 Optical Characteristics
5.0 Signal Interface
5.1 Connectors
5.2 Signal Pin
5.3 Signal Description
5.4 Signal Electrical Characteristics
5.5 Signal for Lamp Connector
6.0 Pixel Format Image
7.0 Parameter Guide Line for CFL Inverter
8.0 Interface Timings
8.1 Timing Characteristics www.DataSheet.co.kr




8.2 Timing Definition
9.0 Power Consumption
10.0 Power ON/OFF Sequence
11.0 Mechanical Characteristics


II Record of Revision
Version and Date Page Old description New Description Remark
0.1. 2001/8/13 All First Edition for All
Customer
0.2 6 Typical White Luminance Typical White Luminance
2001/10/31 200 nit 150 nit
0.3 2002/2/7 6, 9 Typical White Luminance Typical White Luminance
150 nit 180 nit
0.4 2002/4/23 6,9 Add luminance uniformity


(C) Copyright AU Optronics, Inc.
August, 2001 All Rights Reserved. B150XN01 Ver.04
2/2
No Reproduction and Redistribution Allowed.

Datasheet pdf - http://www.DataSheet4U.ne
www.DataSheet.co.kr




(C) Copyright AU Optronics, Inc.
August, 2001 All Rights Reserved. B150XN01 Ver.04
3/3
No Reproduction and Redistribution Allowed.

Datasheet pdf - http://www.DataSheet4U.net/
1.0 Handing Precautions
1) Since front polarizer is easily damaged, pay attention not to scratch it.
2) Be sure to turn off power supply when inserting or disconnecting from input connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration or
spots.
4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
5) Since the panel is made of glass, it may break or crack if dropped or bumped on hard
surface.
6) Since CMOS LSI is used in this module, take care of static electricity and insure
human earth when handling.
7) Do not open nor modify the Module Assembly.
8) Do not press the reflector sheet at the back of the module to any directions.
9) In case if a Module has to be put back into the packing container slot after once it was
taken out from the container, do not press the center of the CCFL Reflector edge.
Instead, press at the far ends of the CFL Reflector edge softly. Otherwise the TFT
Module may be damaged.
10) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor
tilt the Interface Connector of the TFT Module.
11) After installation of the TFT Module into an enclosure (Notebook PC Bezel, for
www.DataSheet.co.kr




example), do not twist nor bend the TFT Module even momentary. At designing the
enclosure, it should be taken into consideration that no bending/twisting forces are
applied to the TFT Module from outside. Otherwise the TFT Module may be damaged.
12) Cold cathode fluorescent lamp in LCD contains a small amount of mercury. Please follow
local ordinances or regulations for disposal.
13) Small amount of materials having no flammability grade is used in the LCD module. The
LCD module should be supplied by power complied with requirements of Limited Power
Source(2.11, IEC60950 or UL1950), or be applied exemption.
14) The LCD module is designed so that the CFL in it is supplied by Limited Current Circuit(2.4,
IEC60950 or UL1950). Do not connect the CFL in Hazardous Voltage Circuit.




(C) Copyright AU Optronics, Inc.
August, 2001 All Rights Reserved. B150XN01 Ver.04
4/4
No Reproduction and Redistribution Allowed.

Datasheet pdf - http://www.DataSheet4U.net/
2.0 General Description
This specification applies to the 15.0 inch Color TFT/LCD Module B150XN01.
This module is designed for a display unit of notebook style personal computer.
The screen format is intended to support the XGA (1024(H) x 768(V)) screen and 262k
colors (RGB 6-bits data driver).
All input signals are LVDS interface compatible.
This module does not contain an inverter card for backlight.




www.DataSheet.co.kr




(C) Copyright AU Optronics, Inc.
August, 2001 All Rights Reserved. B150XN01 Ver.04
5/5
No Reproduction and Redistribution Allowed.

Datasheet pdf - http://www.DataSheet4U.net/
2.1 Display Characteristics
The following items are characteristics summary on the table under 25 condition:
ITEMS Unit SPECIFICATIONS

Screen Diagonal [mm] 381

Active Area [mm] 304.1 X 228.1

Pixels H x V 1024(x3) x 768

Pixel Pitch [mm] 0.297X0.297

Pixel Arrangement R.G.B. Vertical Stripe

Display Mode Normally White

Typical White Luminance [cd/m2] 180 (5 point average)
(ICFL=6.0mA)
Luminance Uniformity 1.25 max. (5 pts)
1.65 max. (13pts)
Contrast Ratio 250

Optical Rise Time/Fall Time [msec] 11/24

Nominal Input Voltage VDD [Volt] www.DataSheet.co.kr
+3.3 Typ.

Typical Power Consumption [Watt] 5.6
(VDD line + VCFL line)
Weight [Grams] 585g typ.

Physical Size [mm] 315.8 x 240.5 x 6.5 max.

Electrical Interface 1 channel LVDS

Support Color Native 262K colors ( RGB 6-bit data
driver )
Temperature Range
Operating [oC] 0 to +50
Storage (Shipping) [oC] -20 to +60




(C) Copyright AU Optronics, Inc.
August, 2001 All Rights Reserved. B150XN01 Ver.04
6/6
No Reproduction and Redistribution Allowed.

Datasheet pdf - http://www.DataSheet4U.net/
2.2 Functional Block Diagram
The following diagram shows the functional block of the 15.0 inches Color TFT/LCD
Module:




Backlight Unit
LCD DRIVE
CARD
6bit color
for R/G/B
data LCD
DSPTMG Controller TFT
Vsync 1024(R/G/B) x 3
Hsync
(3 pairs LVDS)
ARRAY/CELL
DC-DC
Converter 768
DTCLK
Ref circuit
(1 pair LVDS)
Y-Driver
VDD
X-Driver
GND
www.DataSheet.co.kr




LCD Connector
Lamp Connector
JAE JAE FI-SEB20P-HF13
JST (2pin)
BHSR-02VS-1
Mating Type JAE FI-S20S
Mating Type SM02B-BHSS-1




(C) Copyright AU Optronics, Inc.
August, 2001 All Rights Reserved. B150XN01 Ver.04
7/7
No Reproduction and Redistribution Allowed.

Datasheet pdf - http://www.DataSheet4U.net/
3.0 Absolute Maximum Ratings
Absolute maximum ratings of the module is as following:
Item Symbol Min Max Unit Conditions

Logic/LCD Drive Voltage VDD -0.3 +4.0 [Volt]

Input Voltage of Signal Vin -0.3 VDD+0.3 [Volt]

CCFL Current ICFL - 7 [mA]
rms
CCFL Ignition Voltage Vs - 1150 Vrms

Operating Temperature TOP 0 +50 [ oC] Note 1

Operating Humidity HOP 8 95 [%RH] Note 1

Storage Temperature TST -20 +60 [ oC] Note 1

Storage Humidity HST 5 95 [%RH] Note 1

Vibration 1.5 10-500 G Hz 2hr/axis, X,Y,Z
(random)
Shock 220 , 2 G ms Half sine wave

www.DataSheet.co.kr




Note 1 : Maximum Wet-Bulb should be 39 and No condensation.




(C) Copyright AU Optronics, Inc.
August, 2001 All Rights Reserved. B150XN01 Ver.04
8/8
No Reproduction and Redistribution Allowed.

Datasheet pdf - http://www.DataSheet4U.net/
4.0 Optical Characteristics
The optical characteristics are measured under stable conditions as follows under 25
condition:
Item Conditions Typ. Note

Viewing Angle [degree]Horizontal (Right) 40 --