Text preview for : Panel_BOE_HYDIS_HV150UX1-102_0_[DS].pdf part of . Various Panel BOE HYDIS HV150UX1-102 0 [DS] . Various LCD Panels Panel_BOE_HYDIS_HV150UX1-102_0_[DS].pdf
Back to : Panel_BOE_HYDIS_HV150UX1- | Home
Global LCD Panel Exchange Center www.panelook.com
PROPRIETARY NOTE
THIS SPECIFICATION IS THE PROPERTY OF BOE HYDIS AND SHALL NOT
BE REPRODUCED OR COPIED WITHOUT THE WRITTEN PERMISSION OF
BOE HYDIS AND MUST BE RETURNED TO BOE HYDIS UPON ITS REQUEST
TITLE : HV150UX1-102
Product Specification
Rev. 0
BOE HYDIS TECHNOLOGY
SPEC. NUMBER PRODUCT GROUP REV. ISSUE DATE PAGE
S864-1300 TFT-LCD PRODUCTS O 2006.06.16 1 OF 33
B2005-C001-A (1/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT LCD PRODUCT O 2006. 06. 16
REVISION HISTORY
REV. ECN NO. DESCRIPTION OF CHANGES DATE PREPARED
O Initial release 2006.6.16 JY. JEONG
SPEC. NUMBER SPEC TITLE PAGE
S864-1300 HV150UX1-102 Product Specification 2 OF 33
B2005-C001-A (2/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT LCD PRODUCT O 2006. 06. 16
Contents
No Item Page
1.0 General Description 4
2.0 Absolute Maximum ratings 6
3.0 Electrical specifications. 7
4.0 Optical specifications. 9
5.0 Interface Connection 14
6.0 Signal Timing Specification 16
7.0 Signal Timing waveforms 19
8.0 Input Signals, Display Colors & Gray Scale of Colors 21
9.0 Power Sequence 22
10.0 Mechanical Characteristics 23
11.0 Reliability Test 24
12.0 Handling & Cautions. 24
13.0 Label 25
14.0 Packing information 27
15.0 EDID Data table 28
Appendix Outline drawing (Front and Rear) 32
SPEC. NUMBER SPEC TITLE PAGE
S864-1300 HV150UX1-102 Product Specification 3 OF 33
B2005-C001-A (3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT LCD PRODUCT O 2006. 06. 16
1.0 GENERAL DESCRIPTION
1.1 Introduction
HV150UX1-102 is a color active matrix TFT LCD module using amorphous silicon TFT's
(Thin Film Transistors) as an active switching devices. This module has a 15.0 inch
diagonally measured active area with UXGA resolutions (1600 horizontal by 1200 vertical
pixel array). Each pixel is divided into RED, GREEN, BLUE dots which are arranged in
vertical Stripe and this module can display 262,144 colors. The TFT-LCD panel used for this
module is a low reflection and higher color type. Therefore, this module is suitable for
Notebook PC. The DC/AC inverter for back-light driving is not built in this model.
LVDS Source Driver
Input
Signal LVDS Rx
+
T/CON
Connector (CN )
TFT LCD Panel
Gate Driver
1600 1200
BACK LIGHT (Fluorescent Lamp)
DC/DC
1
VDD
Gamma
Vcom
CN2
Reflector
LAMP 1 HOT (Pink)
2 COLD (Black)
Note) The output of the inverter may change according to the material of the
reflector.
SPEC. NUMBER SPEC TITLE PAGE
S864-1300 HV150UX1-102 Product Specification 4 OF 33
B2005-C001-A (3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT LCD PRODUCT O 2006. 06. 16
1.2 Features
z 15.0 UXGA FFS
z Thin and light weight
z 3.3 V power supply
z 2 Channel LVDS Interface
z sRGB Mode support
z Single CCFL (Bottom side/Horizontal Direction)
z 262,144 colors
z Data enable signal mode
z Side Mounting Frame
z Green Product (RoHS)
z On Board EDID chip
z High contrast ratio
1.3 General Specification
The followings are general specifications at the model HV150UX1-102. (listed in Table 1.)
Parameter Specification Unit Remarks
Active area 304.8 (H) 228.6 (V) (15.0" diagonal) mm
Number of pixels 1600(H) 1200(V) pixels
Pixel pitch 0.1905(H) 0.1905(V) mm
Pixel arrangement RGB Vertical stripe
Display colors 262,144 colors
Display mode Normally Black
Dimensional outline 317.3r0.5(H) 242.0r0.5(V) 6.5(D:max) mm
Weight 540 (typ.) g
Surface treatment AG(H45%)/AR/2H
Back-light Bottom edge side, 1-CCFL type Note 1
Power consumption PD : 2.0 (2.2 @ sRGB Mode) W
PBL : 4.1 W IL=6.5mA
Ptotal : 6.2 (6.3 @ sRGB Mode) W
Note 1: CCFL (Cold Cathode Fluorescent Lamp)
SPEC. NUMBER SPEC TITLE PAGE
S864-1300 HV150UX1-102 Product Specification 5 OF 33
B2005-C001-A (3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT LCD PRODUCT O 2006. 06. 16
2.0 ABSOLUTE MAXIMUM RATINGS
The followings are maximum values which, if exceed, may cause faulty operation or
damage to the unit. The operational and non-operational maximum voltage and current
values are listed in Table 2.
< Table 2. Absolute Maximum Ratings>
Parameter Symbol Min. Max. Unit Remarks
Power Supply Voltage VDD -0.3 4.0 V
Logic Supply Voltage VIN -0.3 VDD+0.3 V
Lamp Current IL 3.0 7.0 mArms (1)
Lamp frequency FL 45 80 kHz
Operating Temperature TOP 0 +50 (2)
Operating Humidity RHOP - 80 %
Storage Temperature TSP -20 +60
Storage Humidity RHST - 90 %
Note (1) Permanent damage to the device may occur if maximum values are exceeded
Functional operation should be restricted to the condition described under normal
operating conditions.
Note (2) Temperature and relative humidity range are shown in the figure below.
95 % RH Max. ( 40 OC Ta)
Maximum wet - bulb temperature at 39 OC or less. (Ta > 40 OC) No condensation.
Relative Humidity ( %RH)
100
95
80
60
Operating Range
40
20
Storage Range
5
0
-40 -20 0 20 40 60 80
Temperature (OC)
SPEC. NUMBER SPEC TITLE PAGE
S864-1300 HV150UX1-102 Product Specification 6 OF 33
B2005-C001-A (3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT LCD PRODUCT O 2006. 06. 16
3.0 ELECTRICAL SPECIFICATIONS
3.1Electrical Specifications
< Table 3. Electrical specifications >
Parameter Min. Typ. Max. Unit Remarks
Power Supply Voltage VDD 3.0 3.3 3.6 V Note1
Permissible Input Ripple
VRF - - 100 mV At VDD = 3.3V
Voltage
610 850 Note1
Power Supply Current IDD - mA
(670) (910) (sRGB mode)
High Level Differential Input
VIH - - + 100
Signal Voltage
mV Vcm = 1.2 V typ
Low Level Differential Input
VIL - 100 - -
Signal Voltage
Back-light Lamp Voltage VBL 600 630 770 Vrms Note2
Back-light Lamp Current IBL 3.0 6.5 7.0 mA
Back-light Lamp operating One Lamp ,
FL 45 60 80 KHz
Frequency Note3
At Ta = 25
1,180 940 - Vrms
Note 4
Lamp Start Voltage
At Ta = 0
1,420 1,180 - Vrms
Note 4
At IBL= 6.5 mA,
Lamp Life 12,000 15,000 - Hrs
Max. Note5
2.0
PD - - W Note1
(2.2)
Note6,
Power Consumption PBL - 4.1 - W
IBL=6.5mA
6.2
Ptotal - - W Note1
(6.3)
SPEC. NUMBER SPEC TITLE PAGE
S864-1300 HV150UX1-102 Product Specification 7 OF 33
B2005-C001-A (3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT LCD PRODUCT O 2006. 06. 16
Notes : 1. The supply voltage is measured and specified at the interface connector of LCM.
The current draw and power consumption specified is for 3.3V at 25 .
Logic current or power in () is the value in case of sRGB
a) Typ : Window XP pattern
b) Max : Vertical sub line pattern (L255)
2. Reference value, which is measured with Samsung Electric SIC-180 Inverter.
(VBL Min is value at IBL Min and VBL Max is value at IBL Max)
3. The lamp frequency should be selected as different as possible from the horizontal
synchronous frequency and its harmonics to avoid interference which may
cause line flow on the display.
4. For starting the backlight unit, the output voltage of DC/AC's transformer should
be larger than the minimum lamp starting voltage.
(1,180 Vrms at 25 & 1,420 Vrms at 0 )
If an inverter has shutdown function it should keep its output for more than
1 second even if the lamp connector open. Otherwise the lamps may not to be
turned on.
5. End of Life shall be determined by the time when any of the following is satisfied
under continuous lighting at 25 and IBL = 6.5[mA] Max Only.
y Intensity drops to 50% of the Initial Value.
6. Calculated value for reference (VBL IBL)
SPEC. NUMBER SPEC TITLE PAGE
S864-1300 HV150UX1-102 Product Specification 8 OF 33
B2005-C001-A (3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT LCD PRODUCT O 2006. 06. 16
4.0 OPTICAL SPECIFICATION
4.1 Overview
The test of Optical specifications shall be measured in a dark room (ambient luminance d 1
lux and temperature = 25r2 ) with the equipment of Luminance meter system (Goniometer
system and TOPCONE BM-5) and test unit shall be located at an approximate distance
50cm from the LCD surface at a viewing angle of and equal to 0q. We refer to