Text preview for : Panel_BOE_HT170E01-300_0_[DS].pdf part of . Various Panel BOE HT170E01-300 0 [DS] . Various LCD Panels Panel_BOE_HT170E01-300_0_[DS].pdf
Back to : Panel_BOE_HT170E01-300_0_ | Home
PROPRIETARY NOTE
THIS SPECIFICATION IS THE PROPERTY OF BOEOT AND SHALL NOT BE
REPRODUCED OR COPIED WITHOUT THE WRITTEN PERMISSION OF BOEOT
AND MUST BE RETURNED TO BOEOT UPON ITS REQUEST
TITLE : HT170E01-300 (for DELL)
Product Specification
Rev. D
BEIJING BOE OPTOELECTRONICS TECHNOLOGY
SPEC. NUMBER PRODUCT GROUP REV. ISSUE DATE PAGE
S864-5010 TFT-LCD D 2007. 10.17 OF 27
(1/3) A4(210 X 297)
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT D 2007. 10.17
REVISION HISTORY
REV. ECN NO. DESCRIPTION OF CHANGES DATE PREPARED
0 - Initial Release 07. 12. 14 H.K.Kim
A - Add Gray Scale: 2.2 0.2 07. 04. 02 Lily Fang
B - Modify Module ID Naming Rule 07. 07. 23 Lily Fang
C - Modify Gray Scale: 2.2 0.3 07. 09. 17 Shawn Zhao
D - Add PPID naming rule; Modify Back cover 07. 10. 17 Lily Fang
outline
SPEC. NUMBER SPEC. TITLE PAGE
S864-5010 HT170E01-300 (for DELL) Product Specification D OF 27
(2/3) A4(210 X 297)
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT D 2007. 10.17
No. Item Page
1.0 General Description 4
2.0 Absolute Maximum Ratings 6
3.0 Electrical Specifications 7
4.0 Optical Specifications 8
5.0 Interface Connection 10
6.0 Signal Timing Specifications 13
7.0 Input Signals, Basic Display Colors & Gray Scale of Colors 16
8.0 Power Sequence 17
9.0 Mechanical Characteristics 18
10.0 Reliability Test 19
11.0 Handling & Cautions 20
12.0 Product Serial Number 21
13.0 Packing 22
14.0 Appendix 24
SPEC. NUMBER SPEC. TITLE PAGE
S864-5010 HT170E01-300 (for DELL) Product Specification D OF 27
B2006-5006-O (3/3) A4(210 X 297)
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT D 2007. 10.17
1.0 GENERAL DESCRIPTION
1.1 Introduction
HT170E01-300 is a color active matrix TFT LCD module using amorphous silicon TFT's
(Thin Film Transistors) as an active switching devices. This module has a 17.0 inch
diagonally measured active area with SXGA resolutions (1280 horizontal by 1024 vertical
pixel array). Each pixel is divided into RED, GREEN, BLUE dots which are arranged in
vertical stripe and this module can display 16.7M colors. The TFT-LCD panel used for this
module is adapted for a low reflection and higher color type.
CN21
CN22
LVDS LVDS Rx Source Driver
Input +
Signal T/CON
+
Connector (CN1 )
Gate Driver
mini-LVDS Tx
TFT LCD Panel
1280 1024
VDD DC/DC
Gamma
Vcom
CN23
CN24
1.2 Features
z LVDS Interface with 2 pixel / clock
z High-speed response
z Low power consumption
z 6-bit (Hi-FRC) color depth, display 16.7M colors
z Incorporated edge type back-light (Four lamps)
z High luminance and contrast ratio, low reflection and wide viewing angle
z DE (Data Enable) & H-Sync & V-Sync mode
z RoHS Compliant
z TCO `03 Compliant
SPEC. NUMBER SPEC. TITLE PAGE
S864-5010 HT170E01-300 (for DELL) Product Specification D OF 27
B2006-5006-O (3/3) A4(210 X 297)
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT D 2007. 10.17
1.3 Application
z Desktop Type of PC & Workstation Use
z Slim-Size Display for Stand-alone Monitor
z Display Terminals for Control System
z Monitors for Process Controller
1.4 General Specification
The followings are general specifications at the model HT170E01-300.
Parameter Specification Unit Remarks
Active area 337.92(H) * 270.336(V) mm
Number of pixels 1280(H) 1024(V) pixels
Pixel pitch 0.264(H) 0.264(V) mm
Pixel arrangement RGB Vertical stripe
Display colors 16.7M colors
Display mode Normally White
Dimensional outline 358.5(H) 296.5(V) 17.0(D) typ. mm
Weight 2250 (max.) gram
Surface Treatment Haze 25%, 3H
Back-light Top/Bottom edge side, 4-CCFL type Note 1
Note : 1. CCFL (Cold Cathode Fluorescent Lamp)
SPEC. NUMBER SPEC. TITLE PAGE
S864-5010 HT170E01-300 (for DELL) Product Specification D OF 27
B2006-5006-O (3/3) A4(210 X 297)
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT D 2007. 10.17
2.0 ABSOLUTE MAXIMUM RATINGS
The followings are maximum values which, if exceed, may cause faulty operation or
damage to the unit. The operational and non-operational maximum voltage and current
values are listed in Table 2.
< Table 2. Absolute Maximum Ratings> [VSS=GND=0V]
Parameter Symbol Min. Max. Unit Remarks
Power Supply Voltage VDD -0.3 5.5 V
Ta = 25
Logic Supply Voltage VIN VSS-0.3 VDD+0.3 V
Back-light Lamp Current IBL 3 7 mA
Back-light Lamp Frequency FL 30 (80) KHz
Operating Temperature TOP 0 +50 1)
Storage Temperature TST -20 +60 1)
Note : 1) Temperature and relative humidity range are shown in the figure below.
Wet bulb temperature should be 39 OC max. and no condensation of water.
(40,90)
(50,50)
(60,29)
SPEC. NUMBER SPEC. TITLE PAGE
S864-5010 HT170E01-300 (for DELL) Product Specification D OF 27
B2006-5006-O (3/3) A4(210 X 297)
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT D 2007. 10.17
3.0 ELECTRICAL SPECIFICATIONS
< Table 3. Electrical specifications > [Ta =25 2 ]
Parameter Min. Typ. Max. Unit Remarks
Power Supply Voltage VDD 4.5 5.0 5.5 V
Note 1
Power Supply Current IDD - 1000 1200 mA
In Rush Current Irush 2.0 3.0 A Note 2
Permissible Input Ripple Voltage VRF 100 mV VDD = 5.0V
High Level Differential Input
VIH - +100 mV
Threshold Voltage
Vcm = 1.2V typ.
Low Level Differential Input
VIL -100 - mV
Threshold Voltage
Back-light Lamp Voltage VBL 560 700 840 Vrms
Back-light Lamp Current IBL 3.0 6.5 7.0 mArms
Back-light Lamp operating Frequency FL 30 - 70 KHz Note 3
1400 Vrms 25 Note 4
Lamp Start Voltage
1700 Vrms 0 Note 5
Lamp Life 50000 Hrs IBL= 6.5mA
PD - 5.0 6.0 W
Power Consumption PBL 18.33 W IBL=6.5mA, Note 6
Ptotal 23.3 24.3 W
Notes : 1. The supply voltage is measured and specified at the interface connector of LCM.
The current draw and power consumption specified is for VDD=5.0V, Frame rate=75Hz and
Clock frequency = 67.5MHz. Test Pattern of power supply current
a) Typ : Black Pattern
b) Max : Dot Pattern
2. Duration of rush current is about 2 ms and rising time of VDD is 520 s 20 %
3. The lamp frequency should be selected as different as possible from the horizontal
synchronous frequency and its harmonics to avoid interference, which may cause line
flow on the display
4. The voltage above this value should be applied to the lamps for more than 1 second to start-up.
Otherwise the lamps may not be turned on.
5. Calculated value for reference (VBL IBL) 4 excluding inverter loss.
SPEC. NUMBER SPEC. TITLE PAGE
S864-5010 HT170E01-300 (for DELL) Product Specification D OF 27
B2006-5006-O (3/3) A4(210 X 297)
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT D 2007. 10.17
4.0 OPTICAL SPECIFICATION
4.1 Overview
The test of Optical specifications shall be measured in a dark room (ambient luminance d 1 lux and
temperature = 25r2 ) with the equipment of Luminance meter system (Goniometer system and TOPCON
BM-5) and test unit shall be located at an approximate distance 50cm from the LCD surface at a viewing
angle of and equal to 0q. We refer to