Text preview for : Panel_BOE_HT185WX1-300_0_[DS].pdf part of . Various Panel BOE HT185WX1-300 0 [DS] . Various LCD Panels Panel_BOE_HT185WX1-300_0_[DS].pdf
Back to : Panel_BOE_HT185WX1-300_0_ | Home
Global LCD Panel Exchange Center www.panelook.com
PROPRIETARY NOTE
THIS SPECIFICATION IS THE PROPERTY OF BOE HF AND SHALL NOT BE
REPRODUCED OR COPIED WITHOUT THE WRITTEN PERMISSION OF BOE HF AND
MUST BE RETURNED TO BOE HF UPON ITS REQUEST
TITLE : B3 HT185WX1-300
Preliminary Product Specification
Rev. P1
HEFEI BOE OPTOELECTRONICS TECHNOLOGY
SPEC. NUMBER PRODUCT GROUP ISSUE DATE PAGE
Rev. P1
TFT-LCD 2010.10.28 OF 28
A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT P1 Oct. 28. 10'
REVISION HISTORY
REV. ECN No. DESCRIPTION OF CHANGES DATE PREPARED
P0 Initial Release 2010.09.01
P1 2010.10.28
SPEC. NUMBER SPEC. TITLE PAGE
B3 HT185WX1-300 Preliminary Product Specification_ Rev.P1 OF 28
A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT P1 Oct. 28. 10'
Contents
C t t
No. Item Page
1.0 General Description 4
2.0 Absolute Maximum Ratings 6
3.0 Electrical Specifications 7
4.0 Optical Specifications 8
5.0 Interface Connection 10
6.0 Signal Timing Specifications 13
7.0
70 Signal Timing Waveforms of Interface Signal 15
8.0 Input Signals, Display Colors & Gray Scale of Colors 17
9.0 Power Sequence 18
10.0 Mechanical Characteristics 19
11.0 Reliability Test 20
12.0 Handling& Cautions 21
13.0 Product Serial Number 22
14.0 Packing 23
15.0 Appendix 25
SPEC. NUMBER SPEC. TITLE PAGE
B3 HT185WX1-300 Preliminary Product Specification _Rev.P1 OF 28
A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT P1 Oct. 28. 10'
1.0 GENERAL DESCRIPTION
1.1 Introduction
HT185WX1-300 is a color active matrix TFT LCD module using amorphous silicon TFT's
(Thin Film Transistors) as an active switching devices. This module has a 18.5 inch
diagonally measured active area with WXGA resolutions (1366 horizontal by 768 vertical
pixel array). Each pixel is divided into RED, GREEN, BLUE dots which are arranged in
vertical stripe and this module can display 16.7M colors. The TFT-LCD panel used for this
module is adapted for a low reflection and higher color type.
LVDS LVDS Rx Source Driver
Input +
Signal T/CON
+
Connector (CN
Gate Driver
Mini LVDS Tx
TFT LCD Panel
1366 768
VDD DC/DC
1 Gamma
)
Vcom
1.2 Features
z LVDS Interface with 1 pixel / clock
z High-speed response
z Low power consumption
z 6-bit (Hi-FRC) color depth, display 16. 7M colors
z Incorporated edge type back-light (One Light Bar)
z High luminance and contrast ratio, low reflection and wide viewing angle
z DE (Data Enable) only
( ) y
z RoHS /TCO 5.0 Compliant
SPEC. NUMBER SPEC. TITLE PAGE
B3 HT185WX1-300 Preliminary Product Specification _Rev.P1 OF 28
A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT P1 Oct. 28. 10'
1.3 Application
z Desktop Type of PC & Workstation Use
z Slim-Size Display for Stand-alone Monitor
z Display Terminals for Control System
z Monitors for Process Controller
1.4 General Specification
The followings are general specifications at the model HT185WX1-300.
1.
Parameter Specification Unit Remarks
Active area 409.8(H) 230.4(V) mm
Number of pixels 1366(H) 768(V) pixels
Pixel pitch 0.3(H) 0.3(V) mm
Pixel arrangement RGB Vertical stripe
Display colors 16.7M colors
Display mode Normally White
Dimensional outline 430.4(H) 254.6(V) 10.9(D) typ. mm
Weight 1330 (typ.) g
Surface Treatment Haze 25%, 3H
Back-light right edge side, 1- LED Light bar
SPEC. NUMBER SPEC. TITLE PAGE
B3 HT185WX1-300 Preliminary Product Specification _Rev.P1 OF 28
A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT P1 Oct. 28. 10'
2.0 ABSOLUTE MAXIMUM RATINGS
The f ll i i l hi h
Th followings are maximum values which, if exceed, may cause faulty operation or
d f lt ti
damage to the unit. The operational and non-operational maximum voltage and current
values are listed in Table 2.
< Table 2. Absolute Maximum Ratings> [VSS=GND=0V]
Symbol Min. Max. Unit Remarks
Parameter
Power Supply Voltage VDD -0.5 5.5 V
Ta = 25
Logic Supply Voltage VIN VSS-0.3 VDD+0.3 V
LED Channel Current IBL - 80 mA
Operating Temperature TOP 0 +50 1)
Storage Temperature TST -20 +60 1)
Note : 1) Temperature and relative humidity range are shown in the figure below.
Wet bulb temperature should be 39 OC max. and no condensation of water.
SPEC. NUMBER SPEC. TITLE PAGE
B3 HT185WX1-300 Preliminary Product Specification _Rev.P1 OF 28
A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT P1 Oct. 28. 10'
3.0 ELECTRICAL SPECIFICATIONS
3.1Electrical Specifications
< Table 3 Electrical specifications >
3. [Ta =25
25 2 ]
Parameter Min. Typ. Max. Unit Remarks
Power Supply Voltage VDD 4.5 5.0 5.5 V
Note1
Power Supply Current IDD - 600 1000 mA
In-Rush Current IRUSH - 2.0 3.0 A Note 2
Permissible Input Ripple Voltage VRF - - 100 mV VDD = 5.0V
High Level Differential Input
VIH - - +100 mV
Threshold Voltage
Low Level Differential Input
VIL -100 - - mV
Threshold Voltage
Differential input voltage |VID | 200 - 600 mV
VIH=100mV,
Differential input common mode voltage Vcm 1.0 1.2 1.5
VIL=-100mV
LED Channel Voltage VL - 41.6 46.8 V
LED Channel Current IL - 60 - mA
LED Lifetime 30,000 - - Hrs I
PD - 3 4.5 W
Power Consumption PBL - 9.98 - W IL=60 mA, Note 5
Ptotal - 12.98
12 98 - W
Notes : 1. The supply voltage is measured and specified at the interface connector of LCM.
The current draw and power consumption specified is for VDD=5.0V, Frame rate=75Hz and
Clock frequency = 95MHz. Test Pattern of power supply current
a) Typ : Color Bar pattern
b) Max : Skip Sub Pixel Pattern
2. Duration of rush current is about 2 ms and rising time of VDD is 520 s 20 %
3. The lamp frequency should be selected as different as possible from the horizontal
synchronous frequency and its harmonics to avoid interference, which may cause line flow on the display
4. The voltage above this value should be applied to the lamps for more than 1 second to start-up. Otherwise the
lamps may not be turned on.
5. Calculated value for reference (VL IL) 4(channel) excluding driver loss. (LED Light bar: 13S4P)
SPEC. NUMBER SPEC. TITLE PAGE
B3 HT185WX1-300 Preliminary Product Specification _Rev.P1 OF 28
A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT P1 Oct. 28. 10'
4.0 OPTICAL SPECIFICATION
4.1 Overview
41O i
The test of Optical specifications shall be measured in a dark room (ambient luminance d 1 lux and temperature =
25r2 ) with the equipment of Luminance meter system (Goniometer system and TOPCONE BM-5) and test unit shall
be located at an approximate distance 50cm from the LCD surface at a viewing angle of and equal to 0q. We refer to