Text preview for : Panel_BOE_HM236WU3-100_1_[DS].pdf part of . Various Panel BOE HM236WU3-100 1 [DS] . Various LCD Panels Panel_BOE_HM236WU3-100_1_[DS].pdf



Back to : Panel_BOE_HM236WU3-100_1_ | Home

Global LCD Panel Exchange Center www.panelook.com




PROPRIETARY NOTE
THIS SPECIFICATION IS THE PROPERTY OF BOE DT AND SHALL NOT BE
REPRODUCED OR COPIED WITHOUT THE WRITTEN PERMISSION OF BOE DT AND
MUST BE RETURNED TO BOE DT UPON ITS REQUEST




Product Specification

MODEL: HM236WU3-100




BEIJING BOE Display TECHNOLOGY




SPEC. NUMBER PRODUCT GROUP Rev.0 ISSUE DATE PAGE
S TFT-LCD 2011. 12. 26 1 OF 27
B2010-8002-O (1/3) A4(210 X 297)



One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com




PRODUCT GROUP REV ISSUE DATE

TFT- LCD PRODUCT 0 2011.12.26



REVISION HISTORY
REV. ECN No. DESCRIPTION OF CHANGES DATE PREPARED
0 Initial Release Dec. 26. 11' Kim Woong




SPEC. NUMBER SPEC. TITLE PAGE
S HM236WU3-100 Product Specification 2 OF 27
B2010-8002-O (2/3) A4(210 X 297)



One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com




PRODUCT GROUP REV ISSUE DATE

TFT- LCD PRODUCT 0 2011.12.26




Contents

No. Item Page

1.0 General Description 4

2.0 Absolute Maximum Ratings 6

3.0 Electrical Specifications 7

4.0 Optical Specifications 8

50
5.0 I t f
Interface Connection
C ti 10

6.0 Signal Timing Specifications 13

7.0 Signal Timing Waveforms of Interface Signal 15

8.0 Input Signals, Display Colors & Gray Scale of Colors 17

9.0 Power Sequence 18

10.0 Mechanical Characteristics 19

11.0 Reliability Test 20

12.0
12 0 Handling& Cautions
H dli & C ti 21

13.0 Product Serial Number 22

14.0 Packing 23

15.0 Appendix 25




SPEC. NUMBER SPEC. TITLE PAGE
S HM236WU3-100 Product Specification 3 OF 27
B2010-8002-O (3/3) A4(210 X 297)



One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com




PRODUCT GROUP REV ISSUE DATE

TFT- LCD PRODUCT 0 2011.12.26


1.0 GENERAL DESCRIPTION

1.1 Introduction

HM236WU3-100 is a color active matrix TFT LCD open cell using amorphous silicon
TFT's (Thin Film Transistors) as an active switching devices. This open cell has a 23.6
inch diagonally measured active area with FHD resolutions (1920 horizontal by 1080
vertical pixel array). Each pixel is divided into RED, GREEN, BLUE dots which are
arranged in vertical stripe and this module can display 16 7M colors The TFT-LCD
16.7M colors.
panel used for this module is adapted for a low reflection and higher color type.



LVDS LVDS Rx Source Driver
Input +
Signal T/CON
+
Connector (CN




Gate Driver




Mini LVDS Tx
TFT LCD Panel
1920 1080
VDD DC/DC
1 Gamma
)




Vcom




1.2 Features

z LVDS Interface with 2 pixel / clock
z High-speed response
z 6-bit (Hi-FRC) color depth, display 16. 7M colors
z High luminance and contrast ratio, low reflection and wide viewing angle
z DE (Data Enable) only
z RoHS/Halogen Free
z TCO 5.0 compliant
z Gamma Correction



SPEC. NUMBER SPEC. TITLE PAGE
S HM236WU3-100 Product Specification 4 OF 27
B2010-8002-O (3/3) A4(210 X 297)



One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com




PRODUCT GROUP REV ISSUE DATE

TFT- LCD PRODUCT 0 2011.12.26



1.3
1 3 Application


z Desktop Type of PC & Workstation Use
z Slim-Size Display for Stand-alone Monitor
z Display Terminals for Control System
z Monitors for Process Controller




1.4 General Specification
The followings are general specifications at the model HM236WU3-100.



1.

Parameter Specification Unit Remarks

Active area 521.28(H) 293.22(V) mm

Number of pixels 1920(H) 1080(V) pixels

Pixel pitch 0.2715(H) 0.2715(V) mm

Pixel arrangement RGB Vertical stripe

Display colors 16.7M colors

Display mode Normally White

Weight 730 (Max.) g

Surface Treatment Haze 25%, 3H




SPEC. NUMBER SPEC. TITLE PAGE
S HM236WU3-100 Product Specification 5 OF 27
B2010-8002-O (3/3) A4(210 X 297)



One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com




PRODUCT GROUP REV ISSUE DATE

TFT- LCD PRODUCT 0 2011.12.26


2.0 ABSOLUTE MAXIMUM RATINGS

The followings are maximum values which, if exceed, may cause faulty operation or
damage to the unit. The operational and non-operational maximum voltage and current
values are listed in Table 2.

< Table 2. Absolute Maximum Ratings> [VSS=GND=0V]

Parameter Symbol Min. Max. Unit Remarks

Power Supply Voltage VDD -0.3 6.0 V
Ta = 25
Logic Supply Voltage VIN VSS-0.3 VDD+0.3 V

Operating Temperature TOP 0 +50 1)

Storage Temperature TST -20 +60 1)




Note : 1) Temperature and relative humidity range are shown in the figure below.
Wet bulb temperature should be 39 OC max. and no condensation of water.

(39,90)




(50,50)



(60,30)




SPEC. NUMBER SPEC. TITLE PAGE
S HM236WU3-100 Product Specification 6 OF 27
B2010-8002-O (3/3) A4(210 X 297)



One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com




PRODUCT GROUP REV ISSUE DATE

TFT- LCD PRODUCT 0 2011.12.26

3.0 ELECTRICAL SPECIFICATIONS

3.1 Electrical Specifications

< Table 3. Electrical specifications > [Ta =25 2 ]

Parameter Min. Typ. Max. Unit Remarks
Power Supply Voltage VDD 4.5 5.0 5.5 V
Note1
Power Supply Current IDD - 900 1100 mA
In-Rush Current IRUSH - 2.0 3.0 A Note 2
Permissible Input Ripple Voltage VRF - - 300 mV VDD = 5.0V
High Level Differential Input
VIH - - +100 mV
Threshold Voltage
Low L
L Level Diff
l Differential I
ti l Input
t
VIL -100 - - mV
Threshold Voltage
Differential input voltage |VID | 200 - 600 mV
Differential input common VIH=100mV,
Vcm 1.0 1.2 1.5
mode voltage VIL=-100mV
Power Consumption PD - 45
4.5 5.5
55 W



Notes 1. The supply voltage is measured and specified at the interface connector of LCM.
The current draw and power consumption specified is for VDD=5.0V,
Frame rate=75Hz,Clock frequency = 92.9 MHz.
Test Pattern of power supply current
a) Typ : Color Test
b) Max : Skip Subpixel255




2. Duration of rush current is about 2 ms and rising time of VDD is 520 s 20 %
3. Calculated value for reference (Input pins*VPIN IPIN) excluding inverter loss.


SPEC. NUMBER SPEC. TITLE PAGE
S HM236WU3-100 Product Specification 7 OF 27
B2010-8002-O (3/3) A4(210 X 297)



One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com




PRODUCT GROUP REV ISSUE DATE

TFT- LCD PRODUCT 0 2011.12.26

4.0 OPTICAL SPECIFICATION
4.1 Overview
The test of Optical specifications shall be measured in a dark room (ambient luminance d 1 lux
and temperature = 25r2 ) with the equipment of Luminance meter system (Goniometer
system and TOPCONE BM-5) and test unit shall be located at an approximate distance 50cm
from the LCD surface at a viewing angle of and equal to 0q. We refer to