Text preview for : Panel_BOE_HM236WU3-100_0_[DS].pdf part of . Various Panel BOE HM236WU3-100 0 [DS] . Various LCD Panels Panel_BOE_HM236WU3-100_0_[DS].pdf



Back to : Panel_BOE_HM236WU3-100_0_ | Home

Global LCD Panel Exchange Center www.panelook.com

PROPRIETARY NOTE
THIS SPECIFICATION IS THE PROPERTY OF BOE DT AND SHALL NOT BE
REPRODUCED OR COPIED WITHOUT THE WRITTEN PERMISSION OF BOE DT AND
MUST BE RETURNED TO BOE DT UPON ITS REQUEST




TITLE : HM236WU3-100
Product Specification
Rev.P1




BEIJING BOE Display TECHNOLOGY




SPEC. NUMBER PRODUCT GROUP Rev.P0 ISSUE DATE PAGE
TFT-LCD 2011.11.2 OF 27
B2010-8002-O (1/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com


PRODUCT GROUP REV ISSUE DATE

TFT- LCD PRODUCT Rev.P1 Nov. 2. 11'



REVISION HISTORY
REV. ECN No. DESCRIPTION OF CHANGES DATE PREPARED
Rev.P0 Initial Release July. 28. 11' Zheng Xiaopan
Rev.P1 2nd Release Nov.2.11' Kim Woong




SPEC. NUMBER SPEC. TITLE PAGE
HM236WU3-100 Open Cell Product Specification_Rev.P1 OF 27
B2010-8002-O (2/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com


PRODUCT GROUP REV ISSUE DATE

TFT- LCD PRODUCT Rev.P1 Nov. 2. 11'



Contents

No. Item Page
1.0 General Description 4
2.0 Absolute Maximum Ratings 6
3.0 Electrical Specifications 7
4.0 Optical Specifications 8
5.0 Interface Connection 10
6.0 Signal Timing Specifications 13
7.0 Signal Timing Waveforms of Interface Signal 15
8.0 Input Signals, Display Colors & Gray Scale of Colors 17
9.0 Power Sequence 18
10.0 Mechanical Characteristics 19
11.0 Reliability Test 20

12.0 Handling& Cautions 21
13.0 Product Serial Number 22
14.0 Packing 23
15.0 Appendix 25




SPEC. NUMBER SPEC. TITLE PAGE
S HM236WU3-100 Open Cell Product Specification_Rev.P1 OF 27
B2010-8002-O (3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com


PRODUCT GROUP REV ISSUE DATE

TFT- LCD PRODUCT Rev.P1 Nov. 2. 11'

1.0 GENERAL DESCRIPTION
1.1 Introduction
HM236WU3-100 is a color active matrix TFT LCD open cell using amorphous silicon
TFT's (Thin Film Transistors) as an active switching devices. This open cell has a 23.6 inch
diagonally measured active area with FHD resolutions (1920 horizontal by 1080 vertical
pixel array). Each pixel is divided into RED, GREEN, BLUE dots which are arranged in
vertical stripe and this module can display 16.7M colors. The TFT-LCD panel used for this
module is adapted for a low reflection and higher color type.




LVDS LVDS Rx Source Driver
Input +
Signal T/CON
+
Connector (CN




Gate Driver




Mini LVDS Tx
TFT LCD Panel
1920 1080
VDD DC/DC
1 Gamma
)




Vcom




1.2 Features

z LVDS Interface with 2 pixel / clock
z High-speed response
z 6-bit (Hi-FRC) color depth, display 16. 7M colors
z High luminance and contrast ratio, low reflection and wide viewing angle
z DE (Data Enable) only
z RoHS/Halogen Free
z TCO 5.0 , compliant
z Gamma Correction



SPEC. NUMBER SPEC. TITLE PAGE
S HM236WU3-100 Open Cell Product Specification_Rev.P1 OF 27
B2010-8002-O (3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com


PRODUCT GROUP REV ISSUE DATE

TFT- LCD PRODUCT Rev.P1 Nov. 2. 11'

1.3 Application

z Desktop Type of PC & Workstation Use
z Slim-Size Display for Stand-alone Monitor
z Display Terminals for Control System
z Monitors for Process Controller




1.4 General Specification
The followings are general specifications at the model HM236WU3-100.



Parameter Specification Unit Remarks

Active area 521.28(H) 293.22(V) mm
Number of pixels 1920(H) 1080(V) pixels
Pixel pitch 0.2715(H) 0.2715(V) mm
Pixel arrangement RGB Vertical stripe
Display colors 16.7M colors
Display mode Normally White
Weight 730 (Max.) g
Surface Treatment Haze 25%, 3H




SPEC. NUMBER SPEC. TITLE PAGE
S HM236WU3-100 Open Cell Product Specification_Rev.P1 OF 27
B2010-8002-O (3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com


PRODUCT GROUP REV ISSUE DATE

TFT- LCD PRODUCT Rev.P1 Nov. 2. 11'


2.0 ABSOLUTE MAXIMUM RATINGS
The followings are maximum values which, if exceed, may cause faulty operation or
damage to the unit. The operational and non-operational maximum voltage and current
values are listed in Table 2.

< Table 2. Absolute Maximum Ratings> [VSS=GND=0V]
Symbol Min. Max. Unit Remarks
Parameter

Power Supply Voltage VDD -0.3 6.0 V
Ta = 25
Logic Supply Voltage VIN VSS-0.3 VDD+0.3 V

Operating Temperature TOP 0 +50 1)

Storage Temperature TST -20 +60 1)




Note : 1) Temperature and relative humidity range are shown in the figure below.
Wet bulb temperature should be 39 OC max. and no condensation of water.




SPEC. NUMBER SPEC. TITLE PAGE
S HM236WU3-100 Open Cell Product Specification_Rev.P1 OF 27
B2010-8002-O (3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com


PRODUCT GROUP REV ISSUE DATE

TFT- LCD PRODUCT Rev.P1 Nov. 2. 11'

3.0 ELECTRICAL SPECIFICATIONS
3.1Electrical Specifications
< Table 3. Electrical specifications > [Ta =25 2 ]

Parameter Min. Typ. Max. Unit Remarks
Power Supply Voltage VDD 4.5 5.0 5.5 V
Note1
Power Supply Current IDD - 900 1100 mA

In-Rush Current IRUSH - 2.0 3.0 A Note 2

Permissible Input Ripple Voltage VRF - - 100 mV VDD = 5.0V

High Level Differential Input
VIH - - +100 mV
Threshold Voltage
Low Level Differential Input
VIL -100 - - mV
Threshold Voltage

Differential input voltage |VID | 200 - 600 mV

VIH=100mV,
Differential input common mode voltage Vcm 1.0 1.2 1.5
VIL=-100mV

Power Consumption PD - 4.5 5.5 W




Notes : 1. The supply voltage is measured and specified at the interface connector of LCM.
The current draw and power consumption specified is for VDD=5.0V, Frame rate=75Hz
Clock frequency = 92.9 MHz. Test Pattern of power supply current
a) Typ : Color Test
b) Max : Skip Subpixel255




2. Duration of rush current is about 2 ms and rising time of VDD is 520 s 20 %
3. Calculated value for reference (Input pins*VPIN IPIN) excluding inverter loss.




SPEC. NUMBER SPEC. TITLE PAGE
S HM236WU3-100 Open Cell Product Specification_Rev.P1 OF 27
B2010-8002-O (3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com


PRODUCT GROUP REV ISSUE DATE

TFT- LCD PRODUCT Rev.P1 Nov. 2. 11'


4.0 OPTICAL SPECIFICATION
4.1 Overview
The test of Optical specifications shall be measured in a dark room (ambient luminance d 1 lux and temperature =
25r2 ) with the equipment of Luminance meter system (Goniometer system and TOPCONE BM-5) and test unit shall
be located at an approximate distance 50cm from the LCD surface at a viewing angle of and equal to 0q. We refer to