Text preview for : 5_04.pdf part of Panasonic VDR-M70 Panasonic VDR-M50 and VDR-M70 Service manual
Back to : Vdr-M50_M70.part1.rar | Home
(3) SAF-H/SAF Circuit Board and L Block
1) Open the LCD monitor (c). 2) Remove three screws [A], two screws [N] and three screws [C]. 3) Close the LCD monitor and open the L block (b) from the rear in the direction of the arrow: Be careful not to damage the SAF-H/SAF circuit board (a) or flat cable between L block and R block (d). 4) Remove the SAF-H/SAF circuit board. The SAF-H/SAF circuit board is a film-like board: Do not bend or fold it. 5) Disconnect the flat cable between L and R blocks. Disconnect the flat cable between L and R blocks: Do not forcibly pull out the flat cable from connectors at this time. 6) Remove the L block from R block (d) in the direction of the arrow.
(1) (1) Unlock (2) Pull
(a) (b) (c) (d)
SAF-H/SAF circuit board L block LCD monitor R block
(2)
(d) 2) [C] 2) [A] 5)
(b)
(c) 2) [A] 4) 1) 6) (a) Pattern no, printed side
3) 2) [C] 2) [N]
Fig. 5-3-3 Right side
2) [N]
[A] M1.7x4 (Black)
[N] M1.7x4 (Silver)
2) [A]
[C] M1.7x4 (Silver)
Fig. 5-3-4 Bottom Side