Text preview for : Pioneer_PDP-5004_PDP-4304_PDP-5014_PDP-4314_[SM].pdf part of Pioneer Pioneer PDP-5004 PDP-4304 PDP-5014 PDP-4314 [SM] Pioneer Pioneer_PDP-5004_PDP-4304_PDP-5014_PDP-4314_[SM].pdf



Back to : Pioneer_PDP-5004_PDP-4304 | Home

ORDER NO.
ARP3221
PDP-5004

PLASMA DISPLAY


PDP-5004
PDP-4304
PDP-5014
PDP-4314
THIS MANUAL IS APPLICABLE TO THE FOLLOWING MODEL(S) AND TYPE(S).
Model Type Power Requirement Remarks
PDP-5004 KUC AC120V
PDP-5014 KUC AC120V
PDP-4304 KUC AC120V
PDP-4314 KUC AC120V




This service manual should be used together with the following manual(s).
Model No. Order No. Remarks
PDP-5004, PDP-5014 ARP3222 SCHEMATIC DIAGRAM, PCB CONNECTION DIAGRAM
PDP-4304, PDP-4314




For details, refer to "Important Check Points for Good Servicing".


PIONEER CORPORATION 4-1, Meguro 1-chome, Meguro-ku, Tokyo 153-8654, Japan
PIONEER ELECTRONICS (USA) INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A.
PIONEER EUROPE NV Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium
PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936
PIONEER CORPORATION 2004
T-ZZY SEPT. 2004 printed in Japan
1 2 3 4

SAFETY INFORMATION

A
This service manual is intended for qualified service technicians ; it is not meant for the casual
do-it-yourselfer. Qualified technicians have the necessary test equipment and tools, and have been
trained to properly and safely repair complex products such as those covered by this manual.
Improperly performed repairs can adversely affect the safety and reliability of the product and may
void the warranty. If you are not qualified to perform the repair of this product properly and safely,
you should not risk trying to do so and refer the repair to a qualified service technician.

WARNING
This product contains lead in solder and certain electrical parts contain chemicals which are known to the state of California to
cause cancer, birth defects or other reproductive harm.
B Health & Safety Code Section 25249.6 - Proposition 65


NOTICE
(FOR CANADIAN MODEL ONLY)
Fuse symbols (fast operating fuse) and/or (slow operating fuse) on PCB indicate that replacement parts
must be of identical designation.

REMARQUE
(POUR MOD