Text preview for : 1502B_SM.pdf part of Tektronix 1502B SM Tektronix 1502B_SM.pdf
Back to : 1502B_SM.pdf | Home
Service Manual
1502B
Metallic Time-Domain Reflectometer
070-6267-04
This document applies for firmware version 5.02
and above.
Warning
The servicing instructions are for use by qualified
personnel only. To avoid personal injury, do not
perform any servicing unless you are qualified to do
so. Refer to the Safety Summary prior to performing
service.
First Printing: June 1996
Revised: February 1998
Instrument Serial Numbers
Each instrument manufactured by Tektronix has a serial number on a panel insert or tag, or stamped on the
chassis. The first letter in the serial number designates the country of manufacture. The last five digits of the
serial number are assigned sequentially and are unique to each instrument. Those manufactured in the
United States of America have six unique digits. The country of manufacture is identified as follows:
B010000 Tektronix, Inc., Beaverton, Oregon, U.S.A.
E200000 Tektronix United Kingdom, Ltd., London, England
J300000 Sony/Tektronix, Japan
H700000 Tektronix Holland, NV, Heerenveen, The Netherlands
Instruments manufactured for Tektronix by external vendors outside the United States are assigned a
two digit alpha code to identify the country of manufacture (e.g., JP for Japan, HL for Honk Kong, IL for
Israel, etc.).
Tektronix, Inc., P Box 500, Beaverton, Oregon 97077, USA
.O.
Printed in U.S.A.
Copyright Tektronix, Inc., 1998. All rights reserved. Tektronix products are covered by U.S. and foreign
patents, issued and pending. TEKTRONIX and TEK are registered trademarks of Tektronix, Inc.
FCC Class A Device
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
commercial environment. This equipment generated, uses, and can radiate
radio frequency energy, and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. Op
eration of this equipment in a residential area is likely to cause harmful interfer
ence, in which case the user will be required to correct the interference at his
own expense.
Changes or modification not expressly approved by Tektronix can affect
emission compliance, and could void the user's authority to operate this
equipment.
The 1502B Metallic Time Domain Reflectometer was designed and manufactured by:
Tektronix, Inc.
100 S.E. Wilson Ave.
Bend, Oregon 97702 U.S.A
Phone: 1 800 835-9433
Certificate of the Manufacturer/Importer
We hereby certify that the Tektronix 1502B Metallic TDR complies with the RF
Interference Suppression requirements of Amtsbl. Vfg 1046/1984. The German
Postal Service was notified that the equipment is being marketed. The German
Postal Service has the right to re test the series and to verify that it complies.
TEKTRONIX
Bescheinigung des Herstellers/Importeurs
Hiermit wird bescheinigt, dab das Tektronix 1502B Metallic TDR