Text preview for : Disassembly_n_Reassembly.pdf part of Samsung Disassembly n Reassembly Samsung Microwave SMH9187ST Service Manual Disassembly_n_Reassembly.pdf
Back to : Disassembly_n_Reassembly. | Home
3. Disassembly and Reassembly
MAGNETRON, MOTOR ASSEMBLY, VENT BLOWER AND HIGH VOLTAGE TRANSFORMER
Oven must be removed from wall.
REMOVING OVEN FROM WALL (2 PEOPLE REQUIRED)
Oven is hooked on metal tabs at bottom of wall mounting plate and to cabinet by (3) top cabinet bolts.
3-1 Disassembly of Assembly Grille and Panel Outer
Parts Explaination Photo Explaination
1. Disconnect oven power.
2. Remove Grille.
Grille
1) Remove 2 screws
2) Slide the Grille to the left, then pull it
straght out.
1. Disconnect oven power.
2. Remove Grille.
3. Remove Screw.(7)
Panel Outer
4. Remove Screw.(4)
9
3. Disassembly and Reassembly
3-1 Disassembly of Assembly Grille and Panel Outer
Parts Explaination Photo Explaination
5. Remove Screw.(4)
6. Remove Screw.(2)
Panel Outer
7. Remove Screw.(2)
Explaination Photo
Explaination
8. Remove Panel Outer.
10
3. Disassembly and Reassembly
3-2 Replacement of High Voltage Transformer and HVC and Base bottom
Parts Explaination Photo Explaination
1. Disconnect Oven Power.
2. Remove Panel Outer.
3. Discharge The High Voltage Capacitor.
ATTENTION : When discharge must become ground
terminal of HVC and metal of around.
High
voltage
capacitor
4. Remove screw.(1)
5. Disconnect the Lead Wire.
1. Remove
Screw.(5)
2. Disconnect
Base
Lamp
Bottom Housing.
3. Remove Base
bottom.
1. Disconnect
Oven Power.
2. Remove the
Base bottom
and Panel
HV Trans Outer.
3. Disassembly
the Bracket
Duct upper
after remove
screw.
11
3. Disassembly and Reassembly
3-2 Replacement of High Voltage Transformer and HVC and Base bottom
Parts Explaination Photo Explaination
4. Disconnect the Lead Wire.
HV Trans
5. Remove screw.(3)
6. Take out the HV Trans.
12
3. Disassembly and Reassembly
3-3 Replacement of Magnetron
Parts Explaination Photo Explaination
Remove the magnetron including the shield
case, permanent magnet, choke coils and
capacitors (all of which are contained in one
assembly).
1. Disconnect all lead wires from the
magnetron.
Magnetron
2. Remove nuts (4) securing the magnetron
to the wave guide.
3. Take out the magnetron very carefully.
NOTE1: When removing the magnetron, make sure that it antenna does not hit any adjacentparts, or it may be
damaged.
NOTE2: When replacing the magnetron, be sure to remount the magnetron gasket in the correct position and make
sure the gasket is in good condition.
PRECAUTION
During replacement, be certain R.F. anode gasket is in place around anode stub.
PERFORM MICROWAVE LEAKAGE TEST
13
3. Disassembly and Reassembly
3-4 Replacement of Door Assembly
Parts Disassembly Photo Explaination
Removal of 1. Open the Assembly Door by degree 90