| Make | Model | Problem | Solution | Date |
| | | |
| Found: 23
|
| ITT | FX6332 | DEAD , EHT STARTS TO RISE BUT STOPS AFTER SECS | OC44 ( 1000mfd 16v ) IN POWER SUPPLY | 14-09-04 |
| Nokia | 6332 Euromono 110' Chassis | Random thick black spots in picture, varying in shape and size according to picture contrast and brightness. | Replace SMD transistor 4T06 (BC858) next to U4647 chip. | 14-09-04 |
| Nokia | 6332 Euromono 110' Chassis | Random thick black spots in picture, varying in shape and size according to picture contrast and brightness. | Replace SMD transistor 4T06 (BC858) next to U4647 chip. | 14-09-04 |
| Nokia | 6332UK | Dead - tripping | S2000AF s/c - check for dry joints at 5C102 | 14-09-04 |
| Nokia | Euromono 2 6332 | Field - 3 coloured lines at top of screen | 6D04 1N4002 leaky between pins 2 & 6 TDA8170 FOP chip | 14-09-04 |
| Philips | 28PW6332/05 | No Txt, Scart skts not wotrking, increased height, no zoom, no widescreen etc | Faulty EEPROM, change then go into service default by shorting two T.P out on small signal board, then pressing MENU and - on TV all settings will be self evident. | 14-09-04 |
| PHILIPS | 28PW6332/05 | VOLUME BARS NOT VISABLE WHEN USING HANDSET | PRESS "MENU" ON TV UNTILL VOLUME BAR DISPLAYED THEN PRESS "I" FOR 3 SEC | 14-09-04 |
| Philips | 29PW6332/05 | NO TEXT, NO DOLBY OR ZOOM FEATURES NOT WORKING | RESET OPTIONS USING SERVICE TOOL PRESS "ALIGN" A MENU APPEARS RESET RELEVENT OPTIONS FROM "N" TO "Y" | 14-09-04 |
| Philips | 32PW6332 | No sound | Enter service mode & check option NI (Nicam) - should be "Y" (yes) next to it | 14-09-04 |
| Philips | 32PW6332 | Service mode adjustments | Short pins S42 & S43 on signals board (upright board on L). Now have various options available | 14-09-04 |
|
|
| Philips | 32W6332/05 | No sound | TDA2616 audio o/p ic & wickman fuse o/c | 14-09-04 |
| Philips | MD1.2E 28PW6332 | Low width & E/W faulty aft repair of dry joints in LOP | Enter service mode and setup E-W and Nicam/Text mode | 14-09-04 |
| Philips | MD1.2E 28PW6332 | No OSD or menus - - pic OK | Scastle pulse ampl low. Measure at R3611 on small sigs panel, should be 4.5v at source & 0.62v at other end of res. If only 2.5v - 3v its too low. Usually caused by Tr7420 leaky in 16:9 module under CRT neck | 14-09-04 |
| Philips | MD1.2E 28PW6332 | no text, no dolby, zoom features not working | reset options. Using dealer R/C press ALIGN and reset relevant options to YES/NO | 14-09-04 |
| Philips | MD1.2E 28PW6332/05 | can't get volume display bars back by using R/C | press MENU on TV untill vol bar displayed, then press ' i ' for 3 sec | 14-09-04 |
| Philips | MD1.2E 28PW6332/05 | E/W concave pic on 4:3 format, Ok on widescreen | adjust for optimum options D1 to D4 for each aspect ratio using service remote RC7150 | 14-09-04 |
| Philips | MD1.2E 28PW6332/05 | int. no red on pic. Text Ok | take out "F" module and resolder pin3 of the socket W54 | 14-09-04 |
| Philips | MD1.2E 28PW6332/05 | line osc int. squegging on super zoom (line tearing) | replace EPROM IC7685 (482220914928) and replace on/off switch | 14-09-04 |
| Philips | MD1.2E 28PW6332/05 | tripping and showing stby light | D6423 BY228 s/c in horiz. Stage | 14-09-04 |
| Philips | MD1.2E 28PW6332C | blank raster with flyback lines | T7366 BC848B on CRT base | 14-09-04 |
| Philips | MD1.2E 28PW6332C | no sound | R1573 (482207152502) o/c near chopper Tx and TDA2616Q (482220932641) s/c on LHS sub-panel | 14-09-04 |
| Philips | MD1.2E AA 29PW6332/05 | Excess width with poor E/W | Dry joints E/W driver Trfmr 5424 | 14-09-04 |
| Philips | MD2.1E 29PW6332/05 | Dark pic, no lum or osd | Scope the sandcastle on pin 37 TDA8366, it must be 4V p-p. if only 3V p-p check for leaky SMD transistor 7420 BC847B (marked 1Ft) on sub-board "16/9 module" near the LOPT | 14-09-04 |