| Make | Model | Problem | Solution | Added | Date |
| | | | |
| Found: 72 |
| Hinari | CT11 | Tripping | Works ok with Q117 on main pcb dis'd - purpose of this tr? | plamensl | 14-09-2004 |
| Hinari | CT11 | Tripping. | Remove base of Q17 the set will work without it! | plamensl | 14-09-2004 |
| Hinari | CT11 | TRIPS IF FRONT PANEL DISCONNECTED SET RUNS | REMOVE BASE Q17 !! | plamensl | 14-09-2004 |
| Hinari | CT14 | Brightness at max with fb lines | Q301 s/c | plamensl | 14-09-2004 |
| Hinari | CT14 | PICTURE TOO BRIGHT CAN'T BE TURNED DOWN | Q301 SC | plamensl | 14-09-2004 |
| Hinari | CT14 ST200 | Uncontrollable brightness & flyback lines. | Q301 s/c collecor to emitter. | plamensl | 14-09-2004 |
| Hinari | CT14 VTV200 | Dead, relay operates at sw on with short squeal from EHT | Going into prot mode - D485 9v1 zener leaky | plamensl | 14-09-2004 |
| Hinari | CT15 | Bright, blank raster clearing with time | C629 100µ 25v | plamensl | 14-09-2004 |
| Hinari | CT15 | Sync missing | Check sandcastle pulse pin 27 IC201 (8v p-p), if ok check line pulses (+?V) pin 25. If missing or low check TXT cables/conns CN901/2. If still missing check 12v on this panel - goes to R949 - could be o/c | plamensl | 14-09-2004 |
| Hinari | CT15 TVA1 | INT WONT COME OUT OF SBY | LISTEN FOR MAINS RELAY , IF NOT CHECK 5v | plamensl | 14-09-2004 |
| Hinari | CT15 TVA1 GX9 | WON'T COME OUT STBY ( INT ) | IF RELAY DOESN'T OPERATE CHECK 5v ON FRONT PANEL OR RELAY DRIVER , IF RELAY WORKS , R802 , 803 100k OR STR5412 | plamensl | 14-09-2004 |
| Hinari | CT15 ST200 VTV20 | Bright blank screen , sometimes clears if left on | C629 100uF 25v oc | plamensl | 14-09-2004 |
| Hinari | CT15 TVA1 | St/by only | Check relay, R802/3 start up res 100k ?w, STR5412 | plamensl | 14-09-2004 |
| Hinari | CT16 | Dead | D522 BY229 s/c | plamensl | 14-09-2004 |
| Hinari | CT16 | Dead | D552 ERD29-06 - used BYW95C in lieu | plamensl | 14-09-2004 |
| Hinari | CT16 | DEAD OR INT DEAD | D552 BEHIND LOPT. ERD29-06 | plamensl | 14-09-2004 |
| Hinari | CT16 | Dead or int dead | D552 ERD19-06 behind LOPTx | plamensl | 14-09-2004 |
| Hinari | CT16 | Hum bar on pic - may start aft time | Change Bridge rect diodes with BY255 even tho' measure ok | plamensl | 14-09-2004 |
| Hinari | CT16 | Int or perm dead | D552 ERD29-06 nla - use Sony 8-719-900-26 (ERD29-08) | plamensl | 14-09-2004 |
| Hinari | CT16 | No sound | Q802 int o/c | plamensl | 14-09-2004 |