File information: | |
File name: | 8200_Section_2.pdf [preview 8200 Section 2] |
Size: | 2217 kB |
Extension: | |
Mfg: | . Various |
Model: | 8200 Section 2 🔎 |
Original: | 8200 Section 2 🔎 |
Descr: | . Various SM scena Orban 8200_Section_2.pdf |
Group: | Electronics > Other |
Uploaded: | 24-06-2020 |
User: | Anonymous |
Multipart: | No multipart |
Information about the files in archive: | ||
Decompress result: | OK | |
Extracted files: | 1 | |
File name 8200_Section_2.pdf OPTIMOD-FM 8200 INSTALLATION 2-1 Section 2 Installation page contents 2-3 Installation of 8200 2-2 Figure 2-1: 8200 Packaging 2-4 Figure 2-2: Opening the Unit 2-5 Figure 2-3: Stereo Encoder Jumpers (Card #2) 2-6 Figure 2-4: Input Termination Jumpers (Card #1) 2-7 Figure 2-5: Input Sensitivity Jumpers (Card #1) 2-8 Figure 2-6: 8200 Power Switch 2-9 Figure 2-7: Closing the Unit 2-13 Figure 2-8: AC Line Cord Wire Standard 2-14 Figure 2-9: Wiring the 25-pin Optically-isolated 2-15 Figure 2-10: Wiring the RS-232 and RS-422 Connectors 2-27 Installation of Studio Level Controller 2-29 Figure 2-11: 8200ST Jumpers 2-30 Figure 2-12: 464A Jumpers 2-35 Figure 2-13: 8100AST Jumpers 2-36 Figure 2-14: 4000 Jumpers 2-37 Figure 2-15: HF Limiter Jumpers 2-37 Figure 2-16: Pre-Emphasis EQ Jumpers 2-38 Figure 2-17: Pre-Emphasis Jumper 2-40 Figure 2-18: Stereo Coupling Jumpers 2-41 System Setup Using QUICK SETUP 2-55 System Setup Using Individual Calibration Controls 2-65 Time and Date 2-68 Security and Pascode Programming 2-74 Remote Control Interface Programming CAUTION The installation and servicing instructions in this manual are for use by qualified personnel only. To avoid electric shock, do not perform any servicing other than that contained in the Operating Instructions unless you are qualified to do so. Refer all servicing to qualified service personnel. 2-2 INSTALLATION OPTIMOD-FM 8200 page Figure 2-1: 8200 Packaging OPTIMOD-FM 8200 INSTALLATION 2-3 Installation of 8200 Allow about 2 hours for installation. Installation consists of: (1) unpacking and inspecting the 8200, (2) optional resetting of jumpers for 8200 options (composite output impedance, input termination, input sensitiv- ity), (3) checking the line voltage setting, fuses and power cord, (4) mounting the 8200 in a rack, (5) connecting inputs, outputs and power, (6) setting the GROUND LIFT switch, (7) optional connecting of remote control leads and (8) optional connecting of computer interface co |
Date | User | Rating | Comment |