Agilent U1583B Current Clamp Operating Instructions U1583-90107 c20130320 [4] free download

File name U1583B Current Clamp Operating Instructions U1583-90107 c20130320 [4].pdf

Agilent U1583B Current Clamp Operating Instructions The U1583B current clamp is a dual range 40 A and 400 A clamp-on AC current clamp. This U1583B current clamp is designed for Agilent handheld digital multimeter (DMM) and Agilent handheld oscilloscope. A BNC-to-banana plug is required to connect the current clamp with the DMM. For the handheld oscilloscope, use a BNC connector to connect the clamp.. Assistance For technical assistance, contact your nearest Agilent Sales Office or visit the Agilent website at www.agilent.com/find/assist for further information. Regulatory Markings The CE mark is a registered trademark of the European Community. This CE mark shows that the product complies with all the relevant European Legal Directives. If it was accompanied by a year, it indicates the year the design was approved. This ISM device complies with Canadian ICES-001. Product contains restricted substance(s) above the maximum value, with 40 year Environmental Protection Use Period. The CSA mark is a registered trademark of the Canadian Standards Association. The C-tick mark is a registered trademark of the Spectrum Management Agency of Australia. This signifies compliance with the Australia EMC Framework regulations under the terms of the Radio Communication Act of 1992. This instrument complies with the WEEE Directive (2002/96/EC) marking requirement. This affixed product label indicates that you must not discard this electrical/electronic product in domestic household waste. Safety Information Please use the Agilent U1583B current clamp only as specified in this manual. Otherwise, the protection provided may be impaired. A WARNING identifies conditions and actions that pose hazards to the user. A CAUTION identifies conditions and actions that may be damaging to the equipment under test. To avoid possible electric shock, personal injury or damage to this instrument, ensure that you use the current clamp safely, and refer to the guidelines below. Range button in release mode. AC : Alternating Current Range ~ 400 A, Output ~ 1 mV/A Caution, risk of danger (Refer to the DC : Direct Current user's and service guide for details) Maximum allowable current 400A MAX measurement is 400 A Ground CAT III 600V Category III 600V over-voltage protection Double Insulation Range button in lock mode. Caution, risk of electric shock (Refer to