| File information: | |
| File name: | control protocol Ver. 6.3.PDF [preview control protocol Ver. 6.3] |
| Size: | 162 kB |
| Extension: | |
| Mfg: | DENON |
| Model: | control protocol Ver. 6.3 🔎 |
| Original: | control protocol Ver. 6.3 🔎 |
| Descr: | DENON Home Theatre System Home Theatre System Denon - S-302 control protocol Ver. 6.3.PDF |
| Group: | Electronics > Other |
| Uploaded: | 19-07-2022 |
| User: | Anonymous |
| Multipart: | No multipart |
| Information about the files in archive: | ||
| Decompress result: | OK | |
| Extracted files: | 1 | |
File name control protocol Ver. 6.3.PDF DENON AVR/AVC control protocol Ver. 6.3 Application model : S-302 Application terminal : RS-232C Connector specification Connector type: DB-9pin female type, slave straight connection (DCE type) ( 1pin : GND , 2pin : TxD , 3pin : RxD , 5pin : Common(GND) , 4,6,7,8,9pin : NC ) Communication format: Synchronous system : Tone step synchronization Communication system : A half duplex Communication speed : 9600bps Character length : 8 bits Parity control : None Start bit : 1 bit Stop bit : 1 bit Communication procedure : Non procedural Communication data length : 135 bytes (maximum) -1- Protocol specification The following three data forms are defined. COMMAND : The message sent to a system(AVR/AVC) from a controller(Touch Panel etc.) A command to a system is given from a controller. EVENT : The message sent to a controller(Touch Panel etc.) from a system(AVR/AVC) The result is sent, when a system is operated directly and a state changes. *The form of EVENT presupposes that it is the same as that of COMMAND. **Refer to the following table for the contents of COMMAND and EVENT. RESPONSE : The message sent to a controller(Touch Panel etc.) from a system(AVR/AVC) if the `request command' (COMMAND+?+CR(0x0D)) has came from a controller. The RESPONSE should be sent within 200ms of receiving the COMMAND. *The form of RESPONSE presupposes that it is the same as that of EVENT. Basic specification : The command by ASCII CODE, parameter expression *ASCII CODE which can be used is from 0x20 to 0x7F : the alphabet and the number of 0-9 , and space (0x20) , Some signs , AND carriage return(0x0D)--- It is used only as a pause sign. Command structure : COMMAND + PARAMETER + CR(0x0D) COMMAND : ASCII CODE of 2 characters ex. SI : Select Input source MS : surround Mode Setting MV : Master Volume setting PW : system PoWer setting PARAMETER : ASCII CODE ( up to 25 characters) ex. DVD : function name CDR/TAPE : function name THX SURROUND EX : surround mode name SUPER STADIUM : surround mode name *Special Parameter--- ? : for request command | ||

| Date | User | Rating | Comment |