Philips FC9026 free download

File name _vacuum_cleaner_©_.pdf

Universe Vacuum cleaner FC9026 Philips Domestic Appliances and Personal Care Service Manual PRODUCT INFORMATION - This product meets the requirements regarding interference suppression on radio and TV. - After the product has been repaired, it should function properly and has to meet the safety requirements as officially laid down at this moment. TECHNICAL INFORMATION - Colour : - Maximum air displacement : - Maximum vacuum water column : - Power consumption (IEC) 230 V : - Duststorage capacity : - Type number dustbag : - Cord length (depends on version) : - Filter system : : : - Dimensions of cleaner : - Dimensions of packaging : - Net weight : - Gross weight : DISASSEMBLY- AND RE-ASSEMBLY ADVISE - Open the appliance, first remove the exhaust filter grille (item 20), and then remove the 2 screws - C of the switch control panel (item 15). C 2x C 9x 14a + b Red persimmon 37 l/sec. 310 cm 1400 W 3L FC8021 7 metres Paper dustbag Exhaust AFS air filter Motor inlet filter 460 x 315 x 270 mm 595 x 395 x 295 mm 5.88 kg 9.135 kg OPTIONAL (accessories) - FC8021 S-bags - FC8030 AFS-filter - FC8031 HEPA Air Filter - FC8033 Active Carbon Filter - FC8034 Upgrate kit Active Carbon Filter - FC8042 Polishing nozzle - FC8043 Turbo brush nozzle Published by Philips Domestic Appliances and Personal Care - To remove the the panel, pos 14a + b must be removed by using a screwdriver to separate the two covers from the panel as shown in the picture. - Undo and remove the 9 screws (T15) - C in the upper housing (item 8). You will require a screwdriver with a 14.5 cm-long shank for this. Srewdriver 4322 009 08490 can be used. - The component configuration shown in the exploded view may differ in case of specific versions. The components are distinguished by means of code numbers. - When the repair is finished, check whether all functions of the appliance work properly. - To disassemble the cord winder, use TORX screwdriver no. T10, which is one of a set consisting of T20; T15; T10; T9; T8; T7 and T6 (code number 4822 395 50145). Printed in the Netherlands © Copyright reserved Subject to modification 03/03 FC9026 REPAIR INSTRUCTION - Item 4, cotton dustbag, is used in countries in which paper dustbags are not available. - If the reel half spring unit is replaced, shaft A must be lubricated with silicone grease. Do not apply any silicone grease to or spill any grease on terminals (43) or conductors (42). - Item 40 is provided with a long cord-winder spring, but both long and short cords can be used in combination with this spring. (L = 9.3 m) - Depending on the original cord, the spare cord must be shortened to the length of the original cord. - The cord winder spring must be tensioned to the maximum level and then be rewound approx. 1.5 turn - Item 13, air valve, opens to cool the motor if the air displacement is too low or if the airflow is blocked. - If the function of the electronic control unit (item 12) is not required, the Triac must be short-circuited in