JBL ES150PW free download

File name Jbl-ES150PW wirelessactsub.pdf

ES Series Wireless Powered Subwoofer ES150PW Service Manual JBL Consumer Products 250 Crossways Park Dr. Woodbury, New York 11797 Released 2008 Discontinued XXXX Rev0 8/2008 ES150PW - CONTENTS BASIC SPECIFICATIONS ...1 DETAILED SPECIFICATIONS ...2 PACKAGING...5 CONTROLS/CONNECTIONS...6 OPERATION ...8 SUBWOOFER EXPLODED VIEW/PARTS LIST...9 TRANSMITTER EXPLODED VIEW/PARTS LIST...10 TEST SET-UP AND PROCEDURE...11 BLOCK DIAGRAMS...13 SUBWOOFER AMP TROUBLESHOOTING... ...17 TRANSMITTER TROUBLESHOOTING... ...18 RECEIVER PCB TROUBLESHOOTING... ...19 P.C.B. DRAWINGS...20 ELECTRICAL PARTS LIST ...27 IC/TRANSISTOR PINOUTS...33 SCHEMATICS...47 ES150PW SPECIFICATIONS Amplifier Power (RMS): Peak Dynamic Power *: Driver: Inputs: Low-Pass Frequency: Frequency Response: Operating Range RF Operating Frequency Subwoofer Dimensions (H x W x D): Transmitter Dimensions (H x W x D): Weight: 300 Watts 500 Watts 10" (250mm) PolyPlasTM Line Level or LFE Variable from 50Hz to 150Hz (24dB/octave) 27Hz ­ 150Hz Up to 75' (22m), depending upon conditions 2.4GHz 18" x 13-1/4" x 16-1/8" (457mm x 337mm x 409mm) 3-3/4" x 4-7/8" x 3-15/16" (95mm x 124mm x 100mm) 39 lb/17.7kg JBL continually strives to update and improve existing products, as well as create new ones. The specifications and details in this and related JBL publications are therefore subject to change without notice. * The Peak Dynamic Power is measured by recording the highest center-to-peak voltage measured across the output of a resistive load equal to minimum impedance of the transducer, using a 50Hz sine wave burst, 3 cycles on, 17 cycles off. 1 ES150PW ES150PW LINE VOLTAGE US 120vac/60Hz EU 230vac/50-60Hz Parameter Amp Section Type (Class AB, D, other) Load Impedance (speaker) AVG System impedance Min System impedance Rated Output Power (120VAC) AVG RMS Dynamic Power THD @ Rated Power THD @ 1 Watt DC Offset Damping factor Input Sensitivity Input Frequency L or R LFE input System Gain (L or R inputs) System Gain (LFE input) Signal to Noise SNR-A-Weighted SNR-unweighted Residual Noise Floor 200W Powered Sub Amp Yes/No Yes Yes Specification D 4 5.18 3.769 200 311 0.5 0.2 10 >50 Hi/Lo Line 108-132 207-253 Unit n/a Ohms Ohms Ohms Watts Watts % % mV-DC DF Nom. 120 230 QA Test Limits n/a n/a n/a n/a 190 Reference 1 0.3 30 20 Unit Vrms Vrms Conditions Notes Normal Operation Normal operation, MOMS required Notes Nominal AP Computed BW from 20 to 500Hz @ 100Hz Domestic version only 120 VAC-60 Hz Average RMS power, 3/20 Cycles 50 Hz, Driven 6dB above it