McIntosh C1000P free download

File name McIntosh-C1000P preamp.pdf

C1000P C1000P PREAMPLIFIER PREAMPLIFIER Performance Specifications ... 2 Notes ... 2 Rear Panel ... 3 Section Location ... 3 Block Diagram ... 4 Interconnection Diagram ... 5 - 6 Main Left Schematic and PCB ... 7 - 20 Main Right Schematic and PCB ... 21 - 34 Phono MC ... 35 - 36 Balance I/O Left Schematic and PCB ... 37 - 38 Y R A N I M I L E R P CONTENTS Balance I/O Right Schematic and PCB ... 39 - 40 Balance Switching Left Schematic and PCB ... 41 - 42 Balance Switching Rightt Schematic and PCB ... 43 - 44 Meter Schematic and PCB ... 45 - 46 Headphone Schematic and PCB ... 47 - 48 Integrator Schematic and PCB ... 49 Parts List ... 50 - 60 Exploded View and Parts List ... 61 - 62 Repacking Instructions ... 65 SERVICE MANUAL PERFORMANCE SPECIFICATIONS Power Requirements 100 Volts, 50/60Hz at 120 watts 110 Volts, 50/60Hz at 120 watts 120 Volts, 50/60Hz at 120 watts 220 Volts, 50/60Hz at 120 watts 230 Volts, 50/60Hz at 120 watts 240 Volts, 50/60Hz at 120 watts Note: Refer to the rear panel of the C1000 Controller for the correct voltage. C1000T: Width is 17-1/2 inches (44.45cm) Height is 6 inches (15.24cm) including feet Depth is 24 inches (61.0cm) including the Front Panel and Interconnect Cables1 Weight C1000C - 39.0 pounds (17.7 kg) net 61.4 pounds (27.9 kg) in shipping carton C1000P - 33.0 pounds (15.0 kg) net 53.6 pounds (24.3 kg) in shipping carton C1000T - 34.0 pounds (15.4 kg) net 54.6 pounds (24.8 kg) in shipping carton 1 General Specifications Overall Dimensions C1000C: Width is 17-1/2 inches (44.45cm) Height is 6 inches (15.24cm) including feet Depth is 24 inches (61.0cm) including the Front Panel, Knobs and Interconnect Cables1 C1000P: Width is 17-1/2 inches (44.45cm) Height is 6 inches (15.24cm) including feet Depth is 24 inches (61.0cm) including the Front Panel and Interconnect Cables1 Interconnect Cables are supplied with the C1000 Preamplifier and C1000 Tube Preamplifier. They are used to connect Preamplifier(s) to the C1000 Controller. NOTES 1. The heavy notes on the schematic denote the primary signal path. 2. Unless otherwise noted, all voltages indicated on the schematics are measured under the following conditions: a. AC input at 120 volts, 50/60Hz. b. All voltages are +/-10% with respect to ground. A high impedance (10 megaohm) voltmeter must be used. 3. Unless otherwise specified: