| Installation_Instruction.pdf | | How to upgrade the Software
1 Connect the AC power and turn "ON" the TV receiver.
2 The USB reader is located on the left of the cabinet near the side control/jack assembly
as shown in Figure1.
Figure1
3 Insert the "USB Drive" into the USB slot as shown in Figure2.
Figure2
Copyright 2011 All Rights Reserved Page 1 of 3
4 Press the "MENU" button on the remote controller.
Use the Arrow buttons on the remote controller to select the "SET UP" menu.
Press the "OK" button on the remote controller to enter the SET UP Menu as shown in Figure.3
Figure3
5 SET UP menu will be displayed as shown in Figure.4
Figure4
6 In the "SET UP" menu, scroll down to the "Software Upgrade" as shown in Figure5.
|
