File name DAEWOO_DWD-M1031.pdf
S/M No. :
: In this Manual, some parts can be changed for improving,
their performance without notice in the parts list. So, if you
need the latest parts information, please refer to PPL(Parts
Price List) in Service Information Center (http://svc.dwe.co.kr).
DAEWOO ELECTRONICS CORP.
http : //svc.dwe.co.kr July. 2008
4. DIRECTION FOR DISASSEMBLY
DOOR LOCK SWITCH
1 Open the door and remove the clamp door as. 2 Separate the gasket from the cabinet front and remove
3 Remove the door lock switch from the cabinet front .
1 Separate the cover pump from the cabinet front and 2 Lay the right-side of the washer on the floor. And sepa
remove screw. rate connectors and hose drain from the pump.
3 Remove the hose drain o from the pump.
DIRECTION FOR DISASSEMBLY 9
HEATER AND THERMISTOR
1 Separate the plate t as from the washer. 2 Separate the case detergent as and remove two
(Remove two screws at rear) screws from panel f.
3 Separate the panel f as from the washer. 4 Separate the cabinet front from the washer.
(Remove the clamp door as and 4 screws)
5 Separate connectors from the heater and remove the 6 Remove the earth terminal and loosen the nut by using
nut by using a box wrench. a box wrench
7 Pull out the heater from the tub.
10 DIRECTION FOR DISASSEMBLY
Firstly, you have to do from 1 to 5 of HEATER AND THERMISTOR DISASSEMBLY.
1 Separate the box inlet as from the washer. 2 Remove the screw of the motor connector.
(remove screws and hose inlet) And separate the connector from the tub.
3 Separate the hose air from the sensor pressure. 4 Lay the front-side of washer on the floor.
And remove four screws.
5 Separate two dampers and the hose drain. 6 Lift up the cabinet as.
7 Separate the belt. 8 Remove two screws from the motor and remove the
screw from the drum using a box wrench.
DIRECTION FOR DISASSEMBLY 11
5. EXPLODE VIEW AND PARTS LIST
BOX INLET AS
No. PART NAME PART CODE SPECIFICATION Q'TY REMARK
A01 HANDLE CASE PEDIR: 3611147310