IBM MPRKITV3-01 PowerPC 601 Design Kit Update Apr95 free download

File name MPRKITV3-01_PowerPC_601_Design_Kit_Update_Apr95.pdf

The PowerPC 601tDesign Kit Update Application Note AN-PPC-005 Updating PowerPC 601 Board Designs to the latest hardware level. Jacqueline Shorter-Beauchamp April 1995 Document Number: MPRKITV3-01 R 2 AN-PPC-005 The PowerPC 601 Design Kit Update Jacqueline Shorter-Beauchamp Updating PowerPC 601 board designs to the latest hardware level. This application note is directed towards designers and system developers who have or may implement a PowerPC 601 design using the PowerPC 601 System Design Kit docu- mentation (MPRKITV1-02 and MPRKITV2-02) and/or design files as a reference. This ap- plication note provides the most current information about the PowerPC 601 motherboard design. The changes in this package provide instructions on updating a PowerPC 601 board design to the latest hardware level and are listed below as follows: 1. Update the PowerPC-to-PCI Bridge components: IBM27 82653 to Rev. 4.0 (8190655) and IBM27-82654 to Rev. 2.1 (93G9874). Included with this package is Application Note AN-PPC-001, Updating PowerPC System Designs from IBM27-82650 Revision 2.0 to Revision 2.1, which provides instructions on the changes that are necessary to update the board design and schematics. See the IBM27-82650 PowerPC to PCI Bridge Chip- set Errata Summary (MPR650UMU-03) for detailed information regarding chipset erra- ta. 2. Change the System I/O Bridge (Intel 82378) from Version IB to Version ZB. Replacing the Version IB part with Version ZB results in changes to the interrupt system and the removal of certain errata. All PCI interrupts now share IRQ15, which is no longer used as an ISA interrupt. IRQ9 and IRQ11 are now available as ISA interrupts, . PCI interrupts now go directly to the 82378. Application Note AN-PPC-002, Upgrading PowerPC 601 Evaluation Boards to Support the Intel SIO 82378ZB, is included with this package to provide the user with detailed implementation instructions. 3. Implement a board ID register set to FEh. Bias the XBus with either 10K Ohm pull-up resistors to +5V or 250 Ohm pull-down resistors to GND. Please reference Section 11.0, System I/O Address Maps, in the revised PowerPC 601 Evaluation Board Technical Specification and User's Guide for a detail description regarding board ID register imple- mentation. 4. Add 10K Ohm pull-up resistors to +5V on the following IRQ lines: IRQ3, IRQ4, IRQ9, IRQ10, IRQ11, and IRQ12. 5. Add a 33uF decoupling capacitor to the SCSI terminator 'Term Power' signal, U32 pin