Samsung Alignment & Adjustment free download

File name Alignment & Adjustment.pdf

Alignment and Adjustments 2. Alignment and Adjustments 2-1 Service Mode 2-1-1 SERVICE MODE Entry Method (General Transmitter) For the General Transmitter 1. Turn the power off and set to stand-by mode. 2. Press the buttons of the transmitter in this order; INFO-MENU-MUTE-POWER ON to turn the set on. 3. The set turns on and enters service mode. For the Factory Transmitter 1. Turn the power on. 2. Press the buttons of the transmitter in this order : INFO-Factory. 3. The set enters service mode. * If you fail to enter service mode, repeat steps 1 and 2 above. 2-1-2 Initial DISPLAY State of SERVICE MODE 2-1-2(A) OSD DISPLAY Factory Mode Current Input Mode Indicates selected input mode 01. Picture Improvement Picture Adjustment 02. Initial Setting Setting the Initial Values 03. PIP/TTX/Test Pattern Setting the Special Features 04. Option-1 Options-1 : Options of the Product Particulars 05. Option-2 Options-2 : Options of the PDP Properties 06. Reset Initializing after saving the adjustments Software Version Information Release : Oct 06 2004 11 : 41 : 14 Version : T-NPL42PEU1-1215 2-1-2(B) Button Operations in SERVICE MODE Menu Displays all menus UP/DOWN Cursor move to select items LEFT/RIGHT Enable to increase and decrease the data of the selected items (ENTER) Confirm your choice(Store OR Enter) Samsung Electronics 2-1 Alignment and Adjustments 2-2 WHITE Balance Coordinates 2-2-1 PS42P4A1 White Balance Adjustment 1. W/B Adjustment is required for the following four modes: DVI-> COMPONENT-> PC->VIDEO 2. Adjustment Method (Signal equipment : MSPG-925LTH, Measurement equipment : CA210) (1) Adjust the target set by adjusting the panel logic and the video DNIe adjustment register in order to determine the referential W/B of the panel with a DVI input, which is the full digital path. (2)For Component adjustment, adjust the adjustment register of AD9883 to align the DTV signal to the DNIe and logic panel value which was fixed with a DVI adjustment so that they are in effect considered to be the same signals. (At this time, do not adjust the gain of AD9883 -> the Highlight W/B does not need to be adjusted since its deviation falls within valid distribution range.) (3)PC adjustment is same as Component adjustment.