| Subject | Text |
| dim ELD display | Hi.
I'm trying to repair my Sony DHC-MD333. The main ELD has suddenly become very dim - the displ |
| If it's a normal plug the out side should be ground and the center signal. |
|
|
| Can't adjust red convergence APEX projection TV | I'm working on an APEX model GB5108 rear projection television. The red picture is pinched slightly |
| There could be two failures:
1) There is a secondary short. (most of the times the PSU will make |
| Alek (or anyone)
Not built in. What needs replacing?? Can anyone describe what to replace - if tran |
| updates! TV made a pop noise then it shuts off. wait few minutes and will turn on again. ( TV only g |
| Visual (magnifying eye) and Scent inspection passed.
Can not see any suspicious capacitors, resi |
| check output | check output voltages on other side of the power block |
| Hi mAte i think i need this program as well and i have found a site that. Sells the programers but w |
| D28 BY299 | Thank you for everyone's help with this.
I found the problem to be D28 being incorrectly oriented |
| JVC 56 Widescreen Color Problem (Model # AV-56WP74) | I have a 2003 JVC 56 Widescreen (Model # AV-56WP74) If I turn the channel to station 4 (No Station |
| Hitachi | I find it unlikely that the parts are not there to fix it. No way would they have to replace the en |
| I hate Pioneer. But, they will sell you complete replacement boards. Figure out which brd it is. The |
| Re: Vizio | [quote="Dan the TV man"]It still could be the power supply or the main board.It might be c |
| HP laserjet 4L - Has anyone experienced this propblem ? | Has anyone experienced this problem ?
And does anyone know the cause of this problem ?
HP lase |
| 50" zenith tv convergance issue | I have a 50" zenith television that i just replaced the hv splitter and focus block on. Originally, |
| Bush ws6671sil - 11AK19Pro chassis - Help needed! | Hello!
First off, this site is probably the most useful electronic repair site I have come across. |
|
|
| Sony KV32V65 power-on problem - please help | I have a power-on problem with a Sony KV32V65. When hot it powers up fine with 2 blinks but occassi |
| sony kp-53s25 | I'm working on a KP53S15 right now. It does the exact same thing. But the thing is if I disconnect |
| Service manual for a kawai SR3 organ | looking for the service manual for the Kawai SR3 electronic organ. The circuit boards have custom ka |
| 52" needs a circuit board. | I have a R52WH74 less than a year old. One of the circuit boards are bad and I am told not availabl |
| Fujitsu Monitor FPC-CRTAAD | Hello to everybody out here in this forum,
l would like to seek help with the above.
l have thi |
| Thomson tv chasses tx91 ps dead | Hi all!
I have a tv to tepair, but I can't solve the problem.
The ps doesn't work at all. I have |
| What about the autocoupler ( Pc......), the controller IC, Can they stop the power going to the seco |
| many thanks | Hi all
Many thanks for your info in this thread.
My 3260w went off with a bang and visible spar |
| I have got the contact detail for the daewoo service centre which is a unit set up by daewoo to sort |
| Look for fluid on the boards. |
| The "BLUE" picture is fine. No weird lines either, just have a completly blue picture. Whe |
| Re: Philips Magnavox 9P6444 64" RPTV has Green Haze | [quote:b1dfe1bdba="NTL1991"]Hello. I have a Philips Magnavox 64" Rear-Projection TV that was ma |
| RCA 52" Convergence Issue - Please help. | Hello,
I have a 52" RCA Model p52921, Chassis ptk195mb.
The problem is that the convergence go |