| Subject | Text |
| Thanks Cogil!
I don't have glow on the CRT at the moment. I know very little about circuits invo |
| changing microfarad values in replacing capacitors in an amp | I want to replace the electrolytic capacitors on a circuit board for the power amplifier section of |
|
|
| a) Get an external audio amplifier with its own speaker. Plug its input into the right front "p |
| Sears 509-14370 TV, chassisA67 | Sears 509-14370 TV, chassisA67, made by JVC, the board is labeled CKF0822-DU3-1. TV turns on when f |
| Capacitior help! | I need to replace two capacitors in a TV that i can see are visibly leaking,i've replaced all the ot |
| re; rca dead | Hi Guys, the power supply has failed in your set(s) without the
model & chassis number how do y |
| Thank you!
I got page on targeted link whith word doc & xml file but have no option for downl |
| I believe your TV audio output come as a dc volt that can blew your aux circuit, if you have oscillo |
| This Parts & Service manual can now be purchased for $10.77 and downloaded immediately after pay |
| resolder all joints in the line output stage, check R629 (27ohms, 1/2w 90 degree tube)(2.7ohms, 1/2w |
| Service Manuals Philips | Dear Webmaster,
I have a Philips service CD's number 16 (2003) full with service doc (TV, DVD, audi |
| Then u could be having a bad transistor, dying up capacitor or bad grounding somewhere. Unlikely to |
| Re: Kenwood Receiver problem | [quote:7db6a202cf="Guest760"]I have a Kenwood KR-A5040 AM/FM Stereo Receiver. It's an older model b |
| DVD9000... Sure do remember the beast. Very nice & expensive unit. I use to work on them ..do ha |
| Circuit diagram for Panasonic SC-HT900 | Hi,
Can anyone give me the location where I can find the cuircuit diagram of Panasonic SC-HT900 s |
| Re: light bulb broke off the wires for main display | [quote:9d1879eb2d="Dean"]I have a 1995 RX-V850 Yamaha Stereo Rec. the through the hole light bulb ha |
| Denon UDM3 No sound output | Hi guys, originally the cd tray wouldn't eject, found the fix for that on here thanks very much work |
|
|
| This monitor requires bot the H-Sync and the V-Sync to be the correct way up ie +ve going or -ve goi |
| Soldering help needed., It don't flow right | I’ve made my first DIY PCB, I’m trying to solder Leds into the holes and I’m a complete newbe, I got |
| re; Mitsubishi | Hi, try inputting a dvd signal into "video input 1" then if you get a picture
it probably is a tun |
| Samsung CLX3175fn Scan problem | Ihave a samsung clx3175fn mfp that seems to scan strange when you use the doc handler if i place a d |
| Bob,
Before condeming any device, best to attempt to narrow it further.
Based on the age & |
| When you say. "digital setup", remember that music that you listen to, is and always will |
| Cut into CD input for MP3 | Hello, I would like to connect my mp3 player to the ribbon wire connecter from my built in CD player |
| Reinstall U31.
Disconnect other amp connector J7/MCON12.
Repeat resistance measurements to SAM |
| VCR panasonic is dead, power supply.......... | Panasonics VCR is dead & the problem is on power supply, i have changed the faulty STR, but ther |
| Re: 5028 Feeder problems | [quote:5db9cb77fb="fireman sam"]Slacken off the 2 thum screws holding the Doc feeder to the copier, |
| Re: Service Manuals | [color=red:756723afa0]Schematics[/color:756723afa0] for these are as follows:
- NAKAMICHIA PA-7 A |
| Klipsch Promedia 2.1 Amplifier Schematic Requested | I purchased a Klipsch Promedia 2.1 off ebay without reading the fine print, and one channel of the A |
| This Parts & Service manual can now be purchased for $11.77 and downloaded immediately after pay |