| Subject | Text |
| Plasma colours odd until it warms up | I have had what sounds like the same issue. I haven't had an LCD I couldn't repair yet, however I'm |
| Vertical Lines | species8472, i think this was more luck than judgement. The vertical line is caused by 1 of 2 reason |
|
|
| here is the color codes:
PIN LABEL FUNCTION COLOR
1 RED Red color signal pink
2 GREEN Green co |
| tv block diagram | This is a bit oversimplified, but....
:[url]http://electronics.howstuffworks.com/tv3.htm[/url] |
| Sony KVX-2552U | Just wanted to add a little bit to the repair tip for this model. I read the tip for intermittent co |
| HeVi, many thanks for the advice but could you please... | Hi, HeVi,
Many thanks for the advice but could you please clarify...
I'm sorry but I'm a bit thi |
| reply | The problem is the tube. Set the G2 a little bit lower. The lines will disappear. |
| Anything is possible. A bit involved depending on your application.. I used to make PCB's and if you |
| Need Owenrs and or Service Manual Please | The AUZ # I have is 1Z9X1951205
This is an Audi Bose radio from a 1991 Audi 200 Quattro
It is a B |
| Re: GoodmansGTV 69W | [quote:98ccbc9cc5="pauldk"]Thanks for replying atom, yeah apparently goodmans "supply" a range of TV |
| It's unfortunate and expensive that all have blown :(
Which ones have blown? Have a set of the 2S |
| [quote:6a60d01696="Anonymous"]It's most definitely a connection problem in the filament circuit for |
| Re: schematic for Kenwood GE-7030 14 Band Graphic Equalizer | [quote:d25d0ab89f="forisco"]Hello !!!
i need schematic diagram for:
[b:d25d0ab89f]Kenwood GE-7030[ |
| RGB adjust or ServiceBook-Sony KV-28FX20B Wide Screen TV | I just got a somewhat used Sony KV-28FX20B 16x9 TV.
It has 2 scart connections that handle several |
| I'll always dip new tips in a bit of solder. So the tip gets a protective coating.
Also, when cle |
| Manual for Bush 2876NTX anyone? | Hi, I have just bought the remote for the Bush 2876NTX but I can't tune the channels in. I can't see |
| 8255 is rather old, but it is cheap and has 3 x 8 I/O ports.
There is a lot written about this IC.
|
|
|
| Big screen tv's,in general. | I thought i hit a GOLD MINE one day-I looked outside in the a.m.,thought i was hallucinating...but n |
| Ha. I guess, since I know very little of these problems, I have started a bit vague. I can tell yo |
| soldering always getting a dull finish, dry ? | hi,
i bought a soldering atation and doing a bit of soldering work on a curcuit board,\
howeve |
| Proview 998A.rar | Proview 998A.rar
0 bit :shock: |
| thanks! | thanks, walter58 for your advice. sounds like you know your stuff! misfortunately, this is the diagn |
| Same problem: Pioneer SD-P5075 - A great TV.. | Our Pioneer SD-P5075 bit the dust.. Turns off immediately on power on sequence. Some chip problem, |
| National Model TC-2186 MR -Display powers off after 10 mins | This TV has been operating problem free up to end 2004 (purchased 1991).
Has developed this probl |
| need schematic/service manual | i checked the database first and was not able to locate it so i thought i would post here. i am in |
| How is the set stuck in standby? Are there any sounds coming from the back of the TV when you switch |
| A bit hard to say without going into the actual troubleshooting...
Worst case: your picture tube |
| Bad tube, green. 1991, 16 years old. Let it die. Tube, about $300 plus labor, move on. Average life |
| I'm not really familiar with DVD's players,but problems like this seems to be
to be on the power su |
| sony cmt cp101 low audio levels | Hi all,
First of all I confirmed that the Q330 power on muting transistor was at fault by substitut |