| Subject | Text |
| Ok, you took a multimeter and set it to ohms and tested E994. And your positive the pico fuse is goo |
| cable input | Remove the tv and replace it with another tv that you know works.To see if its the cable connection |
|
|
| philips monitor#201B10/00,fcc id:A3KM094 | Hi can anyone tell me where to find a schematic for philips model 201B10/00 20 inches monitor, i nee |
| Newbie need help - Samsung CRT TV | hi i'm new at this ...... i have a samsung tv ,chassis KA50Z ........and all i seem to get is some w |
| enclosed pictures | The 1st time the replacement transistor was fitted the insulating washer must not of been fitted cor |
| NAD 7240 Amplifier Idle current adjustment question/clarific | Hello all,
I'm currently working on the finishing touches to an NAD 7240 PE receiver and during the |
| [quote:84957fbee8="Anonymous"][quote:84957fbee8="Anonymous"]Yes, have test equipment.
It's old r |
| STR-DE875 Service Manual is needed (or just a part of it) | Hello folks! ;) i'm new to this forum and i've very pleased with it since it might solve my problem. |
| Toshiba TV 14R21 (PWB-1386 Board) keeps power on and off | [quote:b8bfe93703="minnie"]Chech r216 10k ohm to see if it's burnt. If so you need to replace the re |
| Sony KP-41S4 projection tv with convergence problem | The former owner replaced the picture tubes, introducing a convergence error for red and blue. After |
| Bush tv (11ak45b5) Picture collaspe | Hi
I have been given a bush tv to have a look and and see if I can repair it. I am after so help |
| humax | Hi
i have a humax with dead power supply , the resistance R2 And R1 i have replaced but it will no |
| [img:bf11ed5aed]http://i67.photobucket.com/albums/h287/rramani/ss12ps.jpg[/img:bf11ed5aed][/URL]
|
| Re: HITACHI C28W410SN | demagnetise crt or live tv off for 1hrs and switch it no it should be ok
[quote |
| I have never seen or heard such upgrade myself before.
If the equipment was originally built in |
| Phillips 32" Silver TV (Not Sure of Model) | I have had my TV for almost 3 years, and it was bought brand new.
It has always worked fine, howe |
| Self tuning guitar | Hi,
This may be a little obscure, but For a college project I am designing a self tuning guitar |
|
|
| hi, I have the same problem with my TV. Do you find any solutions? :roll: |
| Re: jvc service manuals for free | [quote:3b1f995637="jims"]i have a wide variaty of jvc service manuals I can send to anyone who needs |
| Clicking on and Off | Have a PX-42vm2a When Power is on it turns on clicking a relay for 3 seconds then goes to standby.. |
| Plasma's are ment for board level replacement. If it's not working I would start with the power supp |
| Interestingly enough, after writing my response above I decided that I would put up a new post with |
| Dear Vtech,,
Thank you very much for your time and for your great information.
You really helped m |
| Re: toshiba model CE35D10 | [quote:d01989a4a3="guest"]I just went to the back of the tv and got the model #. If anyone can give |
| Re: jvc service manuals for free | [quote:7f5e228083="jims"]i have a wide variaty of jvc service manuals I can send to anyone who needs |
| :idea: Wow, that is an oldie. as a matter of fact used to sell/Svc Vector research & liked them |
| Big set of Moonraker 4 beams with a CB Radio running say...ah 110% modulation, swinging say 200 watt |
| Sony KV-21GMR1 | my Sony KV-21GMR1 is shutting down when u turn it on...you have to turn it on and on and on..before |
| Hi, Lee !
This effect looks like a deffect of system controller IC,expecially if the buttons don't |
| [quote:b54fb7477b="vtech"]Not familiar with the specific unit, some mechanism loop basics to check |