| Subject | Text |
| AEG 72600 Washing Machine Water Distribution Gears | This photograph(sorry it's out of focus) shows the correct position of the water distributor timing |
| [quote:47de80044e="Anonymous"]Your CRT is getting a layer of dead material on the cathodes of each g |
|
|
| In looking at the schematic, RY501 is sourced with +15V DC.
Is your reading of 11.6~11.8V with rela |
| technosat circuit diagram | hi want to repair , power supply is dead , can not read the componnents , the receiver is technosat |
| sony kp-53s25 | I have a sony kp-53s25. It only stays in standby. When I first plug it in a relay in the power sup |
| zenith dvd5201 | I'm writing two years later but did you solve this problem. I'm having the same issue. |
| MEMORY MAP Electronics and Robotics | Memory map for single-chip, expanded multiplexed, special bootstrap, and special test. Memory locati |
| TV LOEWE E3000 (CT1170) Service Manual or Schema | It does sound like the chroma chip as text and settings config drive the crt by switching the gun dr |
| SOLUTION | OK. Its an adm turion laptop with a sis chipset. There is nothing wrong with the motherboard. The pr |
| repairs for phillips 117cm rear projection model 46pp8621 | Hello out there looking for a converge for my Tv the colour guns were replaced but have since found |
| The power supply is probably bad and it makes 3 attempts at power up and goes into safe mode to prev |
| Check if you have 340Vdc across the big capacitor. It is just rectified ac. Maybe it will be more li |
| fortec star | :evil: sorry need for the fortec star life time ultra
power supply only
thanks
joe |
| Service Manual: Samsung 32" TV TXN3245FP (K55A?) | I have a Samsung TXN3245FP (USA/NTSC) that I need to get back to factory settings for V-AMP, V-SHIFT |
| Writing good curriculum vitae is the entry point for an interview. It is through an inspiring CV tha |
| SOLUTION | OK. Its an adm turion laptop with a sis chipset. There is nothing wrong with the motherboard. The pr |
| Re: 25" Console TV Need To Release Vacuum Safely | [quote:9a7acdf5ff="AshTray900"]Is there a way to stabalize the vacuum in a CRT tube without causing |
|
|
| yes | it probably is the problem. Make sure to clean the cpu heatsink from any dust. Also apply new therma |
| Is this external power supply or build in?
If it is external, just buy an adapter with proper power |
| topfield 300ci | Hi i am looking for a diagram of power supply of the above receiver or topfield general does anyone |
| mitsubishi vs-50609 service manual needed | need service manual for this projo. power supply not running. anyone have a link or manual? |
| PM spam | I am aware that there has been a considerable amount of PM spam via the forum lately. I am trying to |
| Check Red color gun transistor at neck of crt or at mainboard. check also traces going to color sour |
| TV TO RED | OK TV´S HAVE 3 GUN´S RED GREEN AND BLUE ON THE "NECK BORD" THAT IT THE SMALL BOR |
| Never mind, I don't ususally post questions w/o research and thought, but I jumped the gun :oops: F |
| schematic | looking for a schematic that for the power supply that comes in the hughes sd-dvr40 tivo DVR
th |
| VCR-FUNAI V-3EEMK6 | I need Service Manual (or Power Supply Onli)of FUNAI V-3EEMK6 |
| Hi,
Euras writing: "Replace IC401 (TDA8171) and R516 (0R82)."
Istvan |
| now hiring home workers worldwide earn up to $250 per day | now hiring home workers worldwide earn up to $250 per day working from home companies id(11671)
now |
| water in the tv | My 3 year old used a squrit gun on the front of my new tv and the areas turned blacked. Please tell |