| Subject | Text |
| http://www.beststuff.co.uk/slx_rf_modulator.htm - there's a lot of things like that come up on a Goo |
| I checked all the soldering and they all seem ok. I'm convinced that the problem is with the line tr |
|
|
| Missing Colour on Dell D1626HT CRT | Colur BLUE is intermittently missing (comes on occasionally and briefly, most likely after cold star |
| "
PostPosted: Tue Nov 13, 2007 11:45 pm Post subject: Yamaha RX-V-850 receiver
Any sugge |
| diagram electronic | Hello ,
I need a diagram electronic , by station amplifier integrated typ AIWA
XA-00 |
| NEC TV N3456 reprogram presets without remote control! | With regard to the NEC brand color TV model N3456 and perhaps other similar models.
Reprogramming o |
| THESE SETS WILL GO INTO STANDBY IF THERE IS A FRAME FAULT, START BY REPLACING THE FRAME IC WHICH MAY |
| Video camera Panasonic NV-DS29EG. | I need service manual for this camera. IC "S3514A" (smd) on PbF is broken.
What function |
| help | I have a Philips em2e Tv and the EW blows.It is tree smd transistor that blows ,and i cant see the |
| re, protect | Not unless you have access to a parts supplier and soldering equipment,
Larry E |
| Thanks | Thanks so much for the help. As soon as I get a chance I"m gonna run down to radio shack and pick u |
| Re: Int. going to Standby | [quote:9df06e2e79="guest"]Hello,
Apart from checking all stabiliser ICs', links (solder top and bot |
| Re: Panasonic TV TX-25MD1 | [quote="Colin"]Panasonic TV. TX-25MD1
Hi there are two problems with this nine-year-old set.
A |
| First of all... Hello to all the Googlers who have been searching for a solution to the same problem |
| Yamaha RX-V-850 receiver | Any suggestions? My receiver will not engage with any FM stations. It just scans but never picks up |
| Re: 50MP1 | Thanks Dooney for your help. Here are some pictures of the NEC 50MP1. I hope you can make sense of |
| [quote:40a845b458="elmir"]Hi
3189 no working:(
There are 2 eeprom: M95320 smd + 25P10 smd
W |
|
|
| If you are lucky only the Fuse is blow.
Close to the power connector inside the nootebook is A SM |
| Just had my repaired this morning $375 | Hi,
It was a simple soldering job.
A little bit of a pain to get to. He did say to put plenty |
| Hitachi 50UX58B Dead w/out Red Light-SUCCESS! | Hi all,
while waiting for a reply to my most recent post...the parts arrived and the two parts [e70 |
| Re: Need help identifying components please. | Hi,
A 6600 system a customer has experienced a similar problem.
Q5 - a H945 transistor (2SC945 |
| Re: Datasheet RS2004FS | [quote="sonyk70"]Hello, where i found the datasheet of RS2004FS?
Many thanks, sonyk.[/quote]
New |
| Fault tuner FM AIWA CT-R 415 YX | Help me! I need a service manual and a tips of repair a tuner of my Aiwa CT-R415 YX. A fault is: the |
| On unit. The display shows "SAFE".
• The TP and TA simultaneously pressing buttons until |
| Diana needs help about NCS2001 amp | Hello,
Can anyone help me on my little project herein. I'm using an rail-to-rail operational sub-1 |
| I think your TXT and OSD are OK.
Check/replace these components in the ABL-line, 2x SMD-zenerdiod |
| Re: HP SMPS dead | You need 2 resistors smd 0,3 ohm. Cut last 5 cm cable /output/ and conect. |
| i should certainly check the soldering in lopt stage ie flyback transformer line drive tranformer an |
| They were known for having bad conn on Eprom IC which will give the same symptoms OR it can be caus |
| The soldering iron is a Pace IR30. Does any body have one lying around their workshop or an altrern |