| Subject | Text |
| Hi,
U sure its the SMPS module faulty? There's power to the audio section of the board... :? Alth |
| Mitsubishi WT-46805 Red Goes and Comes | I have an old rear projection Mits. For some time now the red has been going out completely the it c |
|
|
| Sony 36XBR450 Problem | My Sony 36XBR450 TV is nine years old and has never had any problems, but now it seems to be losing |
| I have seen the caps go leaky, basically turn into a resistor. it wont read shorted but when voltage |
| thx for the info, I did some more research: the BU808DF seems to be a Line Output Transistor (LOPTR |
| You say 32" projection TV. I'm unaware of a 32" projection TV. Should have a picture tube. Resolder |
| TX-960 or followup | Yeah, I saw that. Vintage. Still could blow out 2 mins after I plug it in.
I'd rather put new pa |
| Onkyo DV-C601 "no disc" problem | I copied this information from another website discussion board. I hope it helps.
I too had the |
| Sorry didn't get to finish my reply. If it is still wet then take the board out and flush it under r |
| Sony CMT CP101 Quiet Volume | Hi Sidsparks Well done you. Consulted photo of NIBBOS for q330 and volume is back to normal. D |
| re; RCA 195 | You didn`t say if the problem is with tuner input or video input ?
does the audio work at start up? |
| [quote:d7cf46b57b="absorbentgnome"]The HT (high-tension) transformer is the transformer usually refe |
| Sony KP-EF41SN2 | Hi people
When I try to turn it on only red light flashing.
Any ideas are welcome.
HOT is ok.
Va |
| Electronics Fan | I want to install a small fan in the wall of my water closet to circulate some conditioned air into |
| Canned air works good. |
| yes it is about the most serious problem you can have, it sounds like the crt is going intermittentl |
| Phillips 60pp9352/17 | I took a broken Phillips 60pp93 off some one's hands and hoped to repair it in my spare time.
Wou |
|
|
| Before getting too far ahead & jumping the gun, check the model number as the HSS2000 that you |
| philips av amplifier | the cooling fan is not working when the set is hot |
| happen to be a plastic rca?
one of those new all plastic tvs? hot and replace the flyback. dont eve |
| Can you check if the power supply is working correctly?
E.g. do you have +B on the HOT transitor? |
| Samsung MH026FPEA Service Manual; | Hello to all!
Best regards to all of you, from Lisbon, Portugal! :D
I need your help.
My air c |
| Certainly need the model to be more exacting, example SA2535T etc, but possibly the unit could be i |
| Couple of quick checks... | First I would physically look into the picture guns. Powered down of course. You are looking for a m |
| I've already checked those transistors. The solder joints seem okay.
I tested the tube's blue gun |
| Board A is on the left hand side correct? Do I need to discharge the gun before taking off the board |
| Sony KP53S25 | It was a neon lamp instead of a cap. I figured out it was going into protect mode, the fault was ma |
| HUGE sigh of relief ! | I was bordering on bummed out, :? hoping there was nothing wrong with my monsters.. I will defi |
| 1st item) Because you don't seem to have any high voltage, I'll would start by checking the HOT (lar |
| If we're talking CRT monitor, it could be that the signal gun isn't off during the sweep return.
Ag |