| Subject | Text |
| Open it up and let it air dry. |
| Can't adjust red convergence APEX projection TV | I'm working on an APEX model GB5108 rear projection television. The red picture is pinched slightly |
|
|
| cmt-cp101 sound problem | i experienced the same problem for the same time today after 4+ years of trouble free use.
came on |
| [quote:0921a0d32b="B00N3"]Sorry for the delay, I was waiting for a buddy to let me borrow his solder |
| I do not agree with Dfarhen, if you do not know what you are doing or do not have a tester for the c |
| I powered up the set with the new LOPT in and changed the BU2508DF for an AF version because quite a |
| Panasonic euro-7 without sound | :D I´m new here...and i dont speak english very well...sorry!
I have a panasonic without sou |
| JVC XV-THA30 DVD Surround Receiver Problem | I remember when these first came on the market and we had several faulty units that were sold to cus |
| Re: PX-42VM3G | [quote:1835e0f0f3="Paul S"]HI,
I'm looking for a service manual/schematic diagram for the 42" |
| Samsung 4215W STK convergence amps keep failing | Hello. Several months ago my blue convergence went out on my Samsung 4215W RPTV. The blue would mov |
| Hitachi Widescreen TV C28WD2TN Red Convergence Problem? | Hi,
I haven't got a massive understanding of certain aspects of CRT TVs although I have fixed a f |
| I'd like to try and repair on my own if possible. Where can I get schematics on this unit? Didn't |
| HP W22 | Well, I checked the voltages and found them to be ok, the problem appears to be the video controller |
| Hi thanks for ur clear & wide advice, I realy appriciate it.
1st Item, I had power ok. but |
| Denon AVR-1601 | Someone gave me one of these after it stopped working for them. When you power it on, you can see th |
| surface mount soldering techniques | Has anybody got some surface mount soldering techniques
The first way I was taught to replace sur |
| Red horizontal lines on sony KV X2993B | Hello,
Thx for this advice.
I can't see any 1000V voltage on the RGB board schema ?
To test the d |
|
|
| hmmm, i might see about the cost of returning the psu and try to replace the capacitors on my own... |
| i think it's just the convergence. the red gun won't move side to side only up and down and the blue |
| have you checked the hot transistor.i should also check diodes etc on secondary side of chopper tran |
| The HT (high-tension) transformer is the transformer usually referred to as the flyback transformer |
| I checked for bridges on the IC's and I also put the original IC's back in. I even tried two new IC' |
| Yes, there is such type of air condition.Panasonic made such type of refreshing room air with built |
| anyone know about HENSON air conditioners? |
| Sony 40'' will not turn on "Unless" | I have a Sony 40XBR800 and starting a few weeks ago, the tv would not go on unless I blew "hot |
| Identification of IC | I am having problem with this TV, Model No 29PT632A, Chessis GR2.4. Green colour of the gun is more. |
| Re: Mitsubishi | Does CRT board have any gun cut off / service switches? Note position, work switch, look for improve |
| Cp 150 is that a capictor ? I have TV open front and back everything is clean , and nothing is leaki |
| Dell Monitor P780 Shut down | My Dell Monitor came up for a second and then shut down with amber light flashing. I have check HOT, |
| Hi!
First what comes to mind is that power supply had gone bad. And so it
can be 2 cases:
1)The |