Subject | Text |
| More than likely spindle motor is on it's way out. Unfortunately almost all of these units use the |
convergence | Have you adjusted the tubes in the back? You can make adjustments easily. In the front there are f |
|
Blaupunkt tv | With you having the speaker too close to the screen you have messed up the purity.The speaker is str |
Sharp 51DT25H stuck in standby | Hi everyone. I'm not a TV repair engineer by trade, but have been landed with a Sharp 51DT25H to rep |
| There are many simple remote control units aimed at hobbyists, available at distributors like RS Com |
| Usually no.
Most units are designed to meet certain tolerances and I am sure monitors have very ti |
emerson microwave at575, model 1989....yikes | My microwave counts down but the magnetron is not turning on... At first I thought it was the touch |
| when you have repaired it check out his speaker system for shorts because he may get a repeat perfor |
Squier Champ 15G guitar amp by Fender | Ok , I'm trying to find some information on the above amp , the one I have has developed a severe hu |
KEF PSW 2500 relay buzz and audio outout buzz | Have just repaired a similar problem with a KEF 2500 - relay was chattering at 50 Hz rate, buzz in s |
| If your unit's panel uses more than one CCFL bulbs, it sounds like one might not be turning on every |
| [quote:e125957d64="jts1957"]Have you tryed unplugging units from powerr outlet for "1 to 2 minu |
TECHNICS RS-TR575 | TAPE MECHANISM SHUTS DOWN MIDWAY IN REVERSE MODE AS THOUGH IT WAS AT END OF CASSETTE. THIS HAPPENS |