| Subject | Text |
| Your lossing vertical information. I'd start by reseating the ribbon cables on the driver/buffer on |
| Re: Another question | [quote:de20e5c1d6="Anonymous"]Sorry to sound dense - but the panel - is that the screen itself (and |
|
|
| Go after the logic board. Too wide spread to be a buffer board. |
| thankyou minnie for advice.
i take it the option bytes is in the service menu, if so any ideas wh |
| Re: Catalog of all electronic and semiconductor component da | [quote:c381792b5a="peter_g"]www.Datasheetpro.com , by DSP Innovations, recently launched a Free sear |
| Plasma colours odd until it warms up | I have had what sounds like the same issue. I haven't had an LCD I couldn't repair yet, however I'm |
| Cory is right. Depending on the brand it's either a buffer board or a driver board, the model # prob |
| Re: HP-R4252 looks like yours | Sounds about right, how much did they charge?
[quote:0f32e2ad8c="VC"]I just had my HP-R4252 repai |
| definetly not the z sus board, either the buffer board at the bottom of the pdp or more likely the p |
| could be x buffer pcb or logic pcb.either. |
| possible bad buffer board |
| 5.5 The Blinking LED Procedure
5.5.1 Introduction
The software is capable of identifying different |
| 50PFP5332D Screen Issue/Repair | Hi everybody,
Im new to this forum so hello! :)
I was attempting to fix my Phillips 50PFP5332D |
| You can try replacing the buffer board but it sounds like a bad panel. |
| Philips chassis L9.2A error code 12 | Does anyone know how to clear error code 12 for the philips tv. It runs for about 10 seconds and tur |
| Hello, I'm repairing a Keithley 3330 LCZ meter. I found that the output voltage is only 1/3 of the c |
| [quote:b47496a6ed="Anonymous"]thanks minnie,
i changed the 24c eeprom which had origanal service |
|
|
| Plasma PHILIPS 42PW9982/12 shifted image | Initially there were six errors 044,090,089,75,76,77. After the replacement of one bloated capacitor |
| samsung HP-R4252 | [quote:fa84dec4b1="minnie"]Check the fuses on the sustain boards and yes I'd replace the y and the y |
| it wont work, not seperate cells for each pixel, once the screen is cracked it needs to be replaced, |
| Sounds like a bad panel. The voltages for VS and VA are on the panel. You changed the Y sustain not |
| [quote:458f746099="gary"]probably a faulty pdp, have a very close look at the screen, check for any |
| Yesterday I had a Samsung plasma that after it was on for about 10 minute would get red horizontal l |
| Bad Panel, I change around 3 a week, I have only fixed one with a buffer board. |
| 2 HD's TOSHIBA DT01ACA100 1 terabyte each suddenly the bios | Hello Guys, I have 2 HD's TOSHIBA DT01ACA100 1 terabyte each suddenly the bios only recognizes 32 mb |
| Look at the Y sustain upper and lower buffer boards for fried IC's. |
| a black bar depending on width usually means the ic on the buffer pcb bad.it draws about 16 lines ea |
| Catalog of all electronic and semiconductor component datash | www.Datasheetpro.com , by DSP Innovations, recently launched a Free search
site for electronic com |