| Subject | Text |
| Check for faulty resistors and capacitors at the output of Power amplifier IC 7100, 7200 and 7300. |
| You said white line in center, of this is down the middle then it's a line scan, usually scan correc |
|
|
| Re: STR-DB725QS | [quote:80f4106bc9="onkel.tom"]Hi Andreas
Have the servicemanual you need.
Check the solderpoints |
| Beko 12.1 chassis tuning doesn't stop on strong signals | Hi all,
This Beko 14213T (chassis 12.1 with UHF only) just continues to scan over all signals. Chan |
| Re Finlux 1000 | I had the same problem about 3 years ago with this model.
Check continuity of line scan coils..shou |
| 50MP1 | Andy, I used to work for NEC and was the European Technical Specialist for Plasma displays. If your |
| Picture squeezes horizontally | Make and model of set would normally be required for more detailed diagnosis.
With the set unplugge |
| Mag 810FD too bright | A hand-me-down from a friend. The monitor is too bright and adjusting brightness and contrast can't |
| Re: 50MP1 | I have acquired 4 NEC 50 MP1 for free. They all pretty much have the same problem. They will displ |
| hola yo tengo el manual de aiwa wx 220 si alguno lo necesita lo puedo escanear en su idioma scxslot@ |
| PX-50XM1 (50MP1) | All,
Just so you all know, below are the pcb labels from the scan board of the 2 capacitors which |
| the set has dry joints, try resoldering the line output and drive areas of the tv, also on those set |